Home › Drivetrain › 8HP51 (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION REAR OIL SEAL
RM3650E _52 Drivetrain _079902 8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE _0387753 AUTOMATIC TRANSMISSION REAR OIL SEAL A

8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION REAR OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for B48)

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for B58)

Hide 58166A 4.REMOVE FRONT FLOOR COVER LH

Hide 58165C 5.REMOVE FRONT FLOOR COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 6.REMOVE EXHAUST PIPE ASSEMBLY (for B48)

Hide 7.REMOVE EXHAUST PIPE ASSEMBLY (for B58)

Hide 58151 8.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

Hide 58151A 10.REMOVE NO. 1 FLOOR HEAT INSULATOR

HINT:

Use the same as for the No. 2 floor heat insulator.


Hide 13.REMOVE OUTPUT FLANGE RADIAL SHAFT SEAL

CAUTION:
·

Materials harmful to health.

Contact with fluids harmful to health!

-

Note and follow safety information on containers.

-

Conduct all work in appropriate personal protective equipment only.




NOTICE:
·

Damage to the automatic transmission assembly.

Damage to the automatic transmission assembly through unapproved automatic transmission fluid.

-

Use only the approved Automatic Gearbox Oil ATF 3+.

-

After completion of repair work, check automatic transmission fluid level.




a.
C406323E01
1.333,1.167 1.667,0.771 true 0.969,1.083 1.333,1.281 0.365,0.198 10 true SST

Using SST and a hammer, release the staked part of the lock nut.

SST
09930-00010  

NOTICE:
·

Use SST with the tapered part facing the shaft.

·

Do not modify the tip of SST with a grinder or other device.

·

Completely release the staked part of the lock nut before removing it.

·

Do not damage the threads of the shaft.




b.
C406297E01
0.917,1.5 1.333,1.5 true 0.583,1.417 0.906,1.615 0.323,0.198 10 true SST 0.333,0.25 1.688,0.469 1.354,0.219 11 false 24 2 380

Using SST, secure the output flange (1).

SST
09960-10010  (09962-01000, 09963-01000)


c.

Release nut with special tool 0 494 212 (24 2 380).

SST
09900-WA060  


d.

Pull off the output flange (1) from the output shaft.


e.
C413393

Slide the special tool 0 494 416 (23 3 160) over the output shaft.

SST
09300-WA110  


f.

Screw the special tool 0 494 416 (23 3 160) into the output flange radial shaft seal in the direction of arrow until the special tool is securely connected to the output flange radial shaft seal.

SST
09300-WA110  


g.
C413394

Turn the bolt (1) into the special tool 0 494 416 (23 3 160) in the direction of arrow until the output flange radial shaft seal is pulled out of the transmission housing.

SST
09300-WA110