Home › Drivetrain › 8HP51 (AUTOMATIC TRANSMISSION / TRANSAXLE) › B48 TRANSMISSION WIRE
RM3650E _52 Drivetrain _079902 8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE _0387759 B48 TRANSMISSION WIRE A

8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE  B48 TRANSMISSION WIRE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the battery state sensor.

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 85010 2.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

Hide 55788A 3.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 12601B 4.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 11271A 5.REMOVE REAR CYLINDER BLOCK COVER

Hide 51219 6.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 58166A 7.REMOVE FRONT FLOOR COVER LH

Hide 58165C 8.REMOVE FRONT FLOOR COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 58151 10.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

Hide 58151A 12.REMOVE NO. 1 FLOOR HEAT INSULATOR

HINT:

Use the same as for the No. 2 floor heat insulator.


Hide 82125 15.REMOVE TRANSMISSION WIRE

a.

Overview of the transmission wire

C411683

NOTICE:
·

Damage to wires when disconnecting connectors and plug connections.

Sheared wires can cause a short circuit.

-

Do not pull on the wires when disconnecting connectors and plug connections.





b.

Release snap-lock couplings (1).


c.
A442111

Feed the cover (2) out toward the top and remove.


d.
A442112

Unlock all connectors (1) of the ECM and pull them off from front to back.


e.
C413366

Unlock connector (1) and pull off.

HINT:

Put the cable to one side.



f.

Unlock and disconnect the connectors (2) from the integrated supply module.


g.

Detach the wiring harness from the cable clip (3).

HINT:

Place wiring harness to one side.



h.
C413364

Unlock connector (1) and remove from starter assembly.


i.

Detach the cable (2) from the clamps and set it aside.


j.
C413363

Unlock the connector (1) and disconnect it from the compressor with magnet clutch.


k.

Detach the cable from the clamp (2) and set it aside.


l.
C413362

Unscrew the E8 bolts (1) on the rear of the cylinder head.


m.

Unlock the lock (2) and detach the cable channel from the cylinder head.


n.

Detach the cable (3) from the cable channel.


o.

Release the cable from the clamp (4).

HINT:

Place wiring harness to one side.



p.
C413365

Unlock the connector (1) on the automatic transmission assembly and pull off.


q.

Loosen the cables from the clamps (2).


r.

Unthread and remove the transmission wire.