Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Detach battery earth lead from battery.
For an auxiliary battery: Disconnect battery earth lead of auxiliary battery.
Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).
Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.
Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.
11115
1.REMOVE CYLINDER HEAD GASKET
17201
2.REMOVE TURBOCHARGER SUB-ASSEMBLY
3.ADJUST NO. 3 CAMSHAFT SUB-ASSEMBLY TO MINIMUM LIFT
4.REMOVE TORSION SPRING
13908A
5.REMOVE GATE
13800
6.REMOVE INTERMEDIATE LEVER
13501A
7.REMOVE INTAKE CAMSHAFT SUB-ASSEMBLY
13053
8.REMOVE NO. 3 CAMSHAFT SUB-ASSEMBLY
15330G
9.REMOVE SERVO MOTOR
13502B
10.REMOVE EXHAUST CAMSHAFT SUB-ASSEMBLY
13801
11.REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
13750
12.REMOVE VALVE LASH ADJUSTER ASSEMBLY
13.REMOVE INTAKE VALVE COMPRESSION SPRING
Using SST, compress each compression spring and remove the 12 intake valve spring retainer locks.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.
Remove the 12 intake valve spring retainers, 12 valve compression spring and from the cylinder head sub-assembly.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.
14.REMOVE EXHAUST VALVE COMPRESSION SPRING
Using SST, compress each compression spring and remove the 12 valve spring retainer locks.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.
Remove the 12 valve spring retainers, 12 exhaust valve compression spring and from the cylinder head sub-assembly.
Arrange the removed parts in such a way that they can be reinstalled to their original locations.