Damage to the air conditioning.
The use of a non-approved clean air filter can lead to functional impairment of the air conditioner.
Only operate the air conditioner with the prescribed clean air filter.
Air conditioning is set to recirculation mode.
50819
1.REMOVE FRONT FLOOR COVER
55011A
2.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55550
3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
87139C
4.REMOVE CLEAN AIR FILTER
87103B
5.REMOVE BLOWER WITH FAN MOTOR SUB-ASSEMBLY
88501
6.CLEAN NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Health impairment in contact with liquids.
Observe safety instructions on the containers and comply with them.
Only carry out work with appropriate personal protective equipment.
Park the vehicle at a suitable washing area, as the effluent cleaning agent escapes through the condensation drain on the transmission tunnel.
Fill the cleaner in special tool 9 429 217.
Air Conditioning System Cleaner
Connect special tool 2 364 733 with special tool 9 429 217.
Build pressure in special tool 9 429 217.
Close all ventilation vents.
Cover the carpet in the work area.
Insert special tool 2 364 733 into the opening of the housing as shown.
Move the special tool 2 364 733 in the opening of the housing in the directions of the arrows from the lower edge (1) to the upper edge (2).
Move special tool 2 364 733 back and forth until the cleaner has been completely sprayed.
After cleaning, drain vehicle for approx. 5 minutes.
87103B
7.INSTALL BLOWER WITH FAN MOTOR SUB-ASSEMBLY
87139C
8.INSTALL CLEAN AIR FILTER
55550
9.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
55011A
10.INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
50819
11.INSTALL FRONT FLOOR COVER