Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DIAGNOSIS


  1. If the skid control ECU detects a malfunction, the ABS, BRAKE, VSC TRAC warning, VSC OFF and/or SLIP indicator lights come on in accordance with the trouble area to warn the driver.
    The table below indicates which lights come on when there is a malfunction in a particular function.


    C124789E01


Indicator / Trouble Area
ABS
EBD
BA
VSC
TRAC
AUTO LSD
A-TRAC
DAC
HAC
ABS Warning Light
○
○
○
-
-
-
-
-
-
Brake Warning Light
-
○
-
-
-
-
-
-
-
VSC TARC Warning Light
○
○
○
○
○
○
○
○
○
VSC OFF Indicator Light
○
○
○
○
○
○
○
○
○
Slip Indicator Light
○
○
○
○
○
○
○
○
○
AUTO LSD Indicator Light
-
-
-
-
-
-
-
-
-
DAC Indicator Light
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
●
(DAC switch ON)
○: Light ON ●: Light ON (Blinking) -: Light OFF

HINT:
  1. The DTCs are simultaneously stored in the memory. The DTCs can be read by connecting the intelligent tester.
  2. This system has a sensor signal check function (Click here). The DTCs can be read by connecting SST (09843-18040) between terminals TS and CG of DLC3 and observing the blinking of the ABS warning light and VSC TRAC warning light, or by connecting the intelligent tester.


WARNING LIGHT AND INDICATOR LIGHT CHECK



  1. C124789E01

    Release the parking brake.

    NOTICE:
    When releasing the parking brake, set chocks to hold the vehicle for safety.

    HINT:
    When the parking brake is applied or the level of the brake fluid is low, the BRAKE warning light comes on.

  2. Check that the ABS warning light, VSC OFF indicator light, VSC TRAC warning light, BRAKE warning light, DAC indicator light, SLIP indicator light and AUTO LSD indicator light come on when the ignition switch is turned on, and go off in about 3 seconds.

    HINT:
    If the lights do not illuminate, confirm whether the bulbs have burned out, and also check the wire harness between the skid control ECU and the combination meter.
    If the light remains on, troubleshoot the effected light circuit by proceeding to the page indicated below.
    Trouble area
    See Page
    ABS warning light circuit
    Click here
    BRAKE warning light circuit
    Click here
    VSC TRAC warning light circuit
    Click here
    DAC indicator light circuit
    Click here
    VSC OFF indicator light circuit
    Click here
    SLIP indicator light circuit
    Click here
    AUTO LSD indicator light circuit
    Click here