Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Result of How to Proceed with Troubleshooting 
Symptom
Suspected Area
See page
Open in CAN Main Wire
Open in CAN Main Bus Line
Click here
Short in CAN Bus Line
Check CAN Bus Lines for Short Circuit
Click here
Short to +B in CAN Bus Line
Check CAN Bus Line for Short to +B
Click here
Short to GND in CAN Bus Line
Check CAN Bus Line for Short to GND
Click here
Open in One Side of CAN Branch Wire
Open in One Side of the CAN Branch Wire
Click here

Communication Stop Mode Table 
Symptom
Suspected Area
See page
"ABS/VSC/TRAC" not displayed on Techstream
Skid Control ECU Communication Stop Mode
Click here
"Steering Angle Sensor" not displayed on Techstream
Steering Angle Sensor Communication Stop Mode
Click here
"Yaw Rate / Deceleration Sensor" not displayed on Techstream
Yaw Rate Sensor Communication Stop Mode
Click here
"Engine" not displayed on Techstream
ECM Communication Stop Mode
Click here
"Combination Meter" not displayed on Techstream
Combination Meter ECU Communication Stop Mode
Click here
"SRS Airbag" not displayed on Techstream
Center Airbag Sensor Communication Stop Mode
Click here