|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | ★ | Precoated part |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| * | For use with a union nut wrench | ● | Non-reusable part |
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
11320B
1.INSTALL NO. 2 TIMING CHAIN COVER ASSEMBLY
Install a new oil pump gasket to the cylinder block sub-assembly.
Clean the contact surfaces of the No. 2 timing chain cover assembly and timing chain cover assembly, and confirm that no oil, moisture, or other foreign matter is on the surfaces.
Apply seal packing in a continuous line to the No. 2 timing chain cover assembly as shown in the illustration.
Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
2.5 to 3.5 mm (0.0984 to 0.138 in.)
Clean the surfaces with non-residue solvent before applying seal packing.
Install the No. 2 timing chain cover assembly within 3 minutes and tighten the bolts within 10 minutes of applying seal packing.
Do not add engine oil for at least 2 hours after installation.
Do not start the engine for at least 2 hours after installation.
Make sure that the diameter at the start and end of each line of seal packing is 5 +/- 2 mm (0.197 +/- 0.0787 in.).
Temporarily install the No. 2 timing chain cover assembly to the timing chain cover assembly with the 17 bolts.
Make sure there is no oil on the bolts. If oil is found on any bolt, clean it before installation.
Tighten the 17 bolts in the order shown in the illustration.
2.INSTALL ENGINE MOUNTING BRACKET RH
Install the engine mounting bracket RH with the 3 bolts in the order shown in the illustration.
After applying seal packing to the No. 2 timing chain cover assembly, install the engine mounting bracket RH within 10 minutes.
3.INSTALL STRAIGHT SCREW PLUG
Using a 10 mm hexagon wrench, install the straight screw plug to the No. 2 timing chain cover assembly.
23191
11.INSTALL FUEL PUMP FLANGE
23100X
12.TEMPORARILY INSTALL FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY
23801P
13.TEMPORARILY INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY
44771
18.INSTALL VACUUM TUBE CONNECTOR HOSE
12262
19.INSTALL NO. 2 VENTILATION HOSE
21.REMOVE ENGINE STAND