| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | REFRIGERANT FROM REFRIGERATION SYSTEM | - | ( )
|
- | - |
| 2 | FRONT FENDER LINER LH | 53876A | - | - | - |
| 3 | ENGINE COOLANT | - | - | ( )
|
- |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 4 | WINDSHIELD WIPER MOTOR AND LINK | - | - | - | - |
| 5 | WATER GUARD PLATE LH | 55735A | - | - | - |
| 6 | NO. 1 FRONT VENTILATOR SEAL | 55815E | - | - | - |
| 7 | OUTER COWL TOP PANEL SUB-ASSEMBLY | 55701J | - | - | - |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 14 | STEERING COLUMN ASSEMBLY | - | - | - | - |
| 15 | NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY | 55086 | - | - | - |
| 16 | NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY | 55084E | - | - | - |
| 17 | NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY | 55085 | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 18 | FRONT SEAT ASSEMBLY RH | - | - | - | - |
| 19 | FRONT SEAT ASSEMBLY LH | - | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 20 | FRONT FLOOR CARPET ASSEMBLY | 58510D | ( )
|
- | - |
| 21 | NO. 4 DASH PANEL INSULATOR PAD | 55216C | ( )
|
- | - |
| 22 | DRAIN COOLER HOSE | 88539J | - | - | - |
| 23 | COOLER UNIT DRAIN HOSE GROMMET | 88539G | ( )
|
- | - |
| ● | Non-reusable part | - | - |
| *A | w/ Headup Display | *B | w/ Telematics Transceiver |
| *C | for TMMF Made | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 31 | AIR CONDITIONER UNIT ASSEMBLY | - | ( )
|
- | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air conditioner unit assembly removal/installation are shown below.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
53876A
2.SEPARATE FRONT FENDER LINER LH
3.DRAIN ENGINE COOLANT
for M15A-FKS:
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE COOLANT (for Engine)>REPLACEMENT
4.REMOVE WINDSHIELD WIPER MOTOR AND LINK
55735A
5.REMOVE WATER GUARD PLATE LH
55815E
6.REMOVE NO. 1 FRONT VENTILATOR SEAL
55701J
7.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY
88707B
8.DISCONNECT SUCTION TUBE SUB-ASSEMBLY B
Remove the bolt.
Rotate the hook connector and disconnect the suction tube sub-assembly B as shown in the illustration.
Remove the O-ring from the suction tube sub-assembly B.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
88710E
9.DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY
Disconnect the air conditioner tube and accessory assembly.
Remove the O-ring from the air conditioner tube and accessory assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
16290F
10.DISCONNECT NO. 3 WATER BY-PASS HOSE ASSEMBLY
Slide the hose clip to disconnect the No. 3 water by-pass hose assembly.
To prevent contamination by foreign matter or water droplets, protect the connecting portions of the No. 3 water by-pass hose assembly and air conditioner radiator assembly with plastic bags.
Do not apply excessive force to the No. 3 water by-pass hose assembly.
Prepare a drain pan or cloth in case the coolant leaks.
87245
11.DISCONNECT INLET HEATER WATER HOSE
Slide the hose clip to disconnect the inlet heater water hose.
To prevent contamination by foreign matter or water droplets, protect the connecting portions of the inlet heater water hose and air conditioner radiator assembly with plastic bags.
Do not apply excessive force to the inlet heater water hose.
Prepare a drain pan or cloth in case the coolant leaks.
12.REMOVE INSTRUMENT PANEL ASSEMBLY
87211
13.REMOVE NO. 1 AIR DUCT
|
|
14.REMOVE STEERING COLUMN ASSEMBLY
55086
15.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
55084E
16.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
55085
17.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
18.REMOVE FRONT SEAT ASSEMBLY RH
for Manual Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL
for Power Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL
19.REMOVE FRONT SEAT ASSEMBLY LH
Use the same procedure as for the RH side.
58510D
20.SEPARATE FRONT FLOOR CARPET ASSEMBLY
Remove the 2 clips to turn back the front floor carpet assembly as shown in the illustration.
55216C
21.REMOVE NO. 4 DASH PANEL INSULATOR PAD
| *a | Cut | - | - |
Cut each claw of the 2 clips to remove the No. 4 dash panel insulator pad.
If the No. 4 dash panel insulator pad is damaged, replace it with a new one.
Remove the 2 clips.
88539J
22.DISCONNECT DRAIN COOLER HOSE
88539G
23.REMOVE COOLER UNIT DRAIN HOSE GROMMET
|
|
83108
24.REMOVE METER MIRROR SUB-ASSEMBLY (w/ Headup Display)
25.REMOVE TELEMATICS TRANSCEIVER WITH BRACKET (w/ Telematics Transceiver)
55308B
26.REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY (for TMMF Made)
27.REMOVE POWER DISTRIBUTION BOX ASSEMBLY WITH MULTIPLEX NETWORK BODY ECU
55306A
28.REMOVE NO. 1 INSTRUMENT PANEL BRACE SUB-ASSEMBLY
82141
29.SEPARATE INSTRUMENT PANEL WIRE
| *A | for Automatic Air Conditioning System | *B | for Manual Air Conditioning System |
| *A | for Automatic Air Conditioning System | *B | for Manual Air Conditioning System |
| *a | Guide | *b | Clamp |
30.REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONER UNIT ASSEMBLY
|
Remove in this Direction | - | - |
31.REMOVE AIR CONDITIONER UNIT ASSEMBLY
|
|