Anti-Lock Brake System
Symptom
| Suspected Area
| See page
|
ABS and/or EBD does not operate
| Check for DTCs again and make sure that the normal system code is output.
|
Click here
|
IG power source circuit (Low power supply)
|
Click here
|
IG power source circuit (High power supply)
|
Click here
|
Front speed sensor (Comparison malfunction)
|
Click here
|
Front speed sensor (Open or short circuit)
|
Click here
|
Front speed sensor (Signal malfunction)
|
Click here
|
Rear speed sensor (Comparison malfunction)
|
Click here
|
Rear speed sensor (Open or short circuit)
|
Click here
|
Rear speed sensor (Signal malfunction)
|
Click here
|
Check the brake actuator assembly with the Techstream. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks.
|
Click here
|
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU).
|
Click here
|
ABS and/or EBD does not operate efficiently
| Check for DTCs again and make sure that the normal system code is output.
|
Click here
|
Front speed sensor (Comparison malfunction)
|
Click here
|
Front speed sensor (Open or short circuit)
|
Click here
|
Front speed sensor (Signal malfunction)
|
Click here
|
Rear speed sensor (Comparison malfunction)
|
Click here
|
Rear speed sensor (Open or short circuit)
|
Click here
|
Rear speed sensor (Signal malfunction)
|
Click here
|
Stop light switch circuit
|
Click here
|
Check the brake actuator assembly with the Techstream. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks.
|
Click here
|
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU).
|
Click here
|
ABS sensor DTC check cannot be done
| Check for DTCs again and make sure that the normal system code is output.
|
Click here
|
TC and CG terminal circuit
|
Click here
|
If the symptoms still occur even after the above circuit in the suspected area has been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU).
|
Click here
|
ABS warning light abnormal
| ABS warning light circuit (Remains on)
|
Click here
|
Brake actuator assembly (Skid control ECU)
|
Click here
|
ABS warning light abnormal
| ABS warning light circuit (Does not come on)
|
Click here
|
Brake actuator assembly (Skid control ECU)
|
Click here
|
Brake warning light abnormal
| Brake warning light circuit (Remains on)
|
Click here
|
Brake actuator assembly (Skid control ECU)
|
Click here
|
Brake warning light abnormal
| Brake warning light circuit (Does not come on)
|
Click here
|
Brake actuator assembly (Skid control ECU)
|
Click here
|
Sensor check cannot be done
| TS and CG terminal circuit
|
Click here
|
Brake actuator assembly (Skid control ECU)
|
Click here
|