Home › Engine / Hybrid System › 1NR-FE LUBRICATION › OIL PUMP › from 2016.04
RM30M0E _51 Engine / Hybrid System _054016 1NR-FE LUBRICATION _0262595 OIL PUMP A

1NR-FE LUBRICATION  OIL PUMP  REMOVAL  


PROCEDURE

Hide 12262 5.REMOVE NO. 2 VENTILATION HOSE

Hide 17168 6.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

Hide 16268 7.DISCONNECT NO. 1 WATER BY-PASS PIPE

Hide 16620 8.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

Hide 11101W 9.REMOVE CAMSHAFT POSITION SENSOR

Hide 11201 10.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

Hide 16321 11.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16326 12.REMOVE NO. 2 WATER INLET HOUSING GASKET

Hide 11301K 13.REMOVE CRANKSHAFT POSITION SENSOR

Hide 11310 15.REMOVE TIMING CHAIN COVER ASSEMBLY

a.
A312261

Remove the 3 bolts and engine mounting bracket RH from the timing chain cover assembly.


b.
A381457C02
1.74,1.729 1.646,1.563 false 1.469,1.5 1.615,1.667 0.146,0.167 10 true *1
*1 Seal Washer


Remove the 24 bolts and seal washer from the camshaft housing sub-assembly, cylinder head sub-assembly, cylinder block sub-assembly and oil pan sub-assembly.


c.
A200635C07
0.365,0.667 0.396,0.521 true 3.146,0.615 2.99,0.458 true 2.969,3.865 2.802,3.677 true 0.458,4.313 0.49,4.135 true 0.302,0.667 0.458,0.854 0.156,0.188 10 true *a 3.094,0.635 3.25,0.823 0.156,0.188 10 true *a 2.896,3.865 3.052,4.052 0.156,0.188 10 true *a 0.396,4.302 0.552,4.49 0.156,0.188 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, remove the timing chain cover assembly by prying between the timing chain cover assembly, cylinder head sub-assembly, cylinder block sub-assembly and oil pan sub-assembly.

NOTICE:

Be careful not to damage the contact surfaces of the timing chain cover assembly, cylinder head sub-assembly, cylinder block sub-assembly and oil pan sub-assembly.



d.
A381452

Remove the 3 oil pump O-rings from the oil pan sub-assembly.


Hide 16.REMOVE PLUG

a.
A312267

Using an 8 mm socket hexagon wrench, remove the plug from the timing chain cover assembly.


Hide 11302A 17.REMOVE TIMING CHAIN COVER OIL SEAL

a.
A197955C14
1,2.479 1.521,1.156 true 2.635,1.833 2.031,1.313 true 0.927,2.51 1.24,2.708 0.313,0.198 10 false *a 2.688,1.771 3,1.969 0.313,0.198 10 false *b
*a Protective Tape
*b Wooden Block


Using a screwdriver with its tip wrapped in protective tape and wooden block, remove the timing chain cover oil seal from the timing chain cover assembly.