Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Gasoline Model with Manual Air Conditioning System) › 2020.07–2020.09
RM36W0E _58 Vehicle Interior _088019 HEATING / AIR CONDITIONING _0420297 AIR CONDITIONING SYSTEM(for Gasoline Model with Manual Air Conditioning System) T

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Gasoline Model with Manual Air Conditioning System)  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

The air conditioning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Gasoline Model with Manual Air Conditioning System)>HOW TO PROCEED WITH TROUBLESHOOTING

·

Perform the inspection when the vehicle is at ambient temperature. If this is not done, there could be a risk of injury depending on the location being inspected.



VEHICLE CHECK ITEMS


HINT:
·

You can reduce the number of systems to check by using the results of the following operation check.

·

Perform the following checks based on Customer Feedback and the vehicle condition.

·

The customer's opinion may not be consistent with the actual problem (eg: the cooling performance of the air conditioner is bad → actually, the wind volume is weak). It is important to check the problem symptoms accurately and judge correctly based on various sources of information.

·

Judgment as to whether the air conditioner panel is normal or abnormal can be judged by checking if the indicator illuminates or turns off when the switch is operated.

·

If the performance of the air conditioner is poor or there is a foul odor, check for clogging in the clean air filter.



Malfunction Operation/Function:
Common Function of Cool and Heater Function Only Cool Air Function Only Heater Function Suspected Area
A/C Switch Operation Blower Operation Recirculation/Fresh Function Air Outlet Changing Function
x o o o x x Go to "Problem Symptoms Table: Air Conditioning Control"
o o o o x o Go to "Problem Symptoms Table: Cooling Function"
o o o o o x Go to "Problem Symptoms Table: Heater Function"
o x o o x x Go to "Problem Symptoms Table: Blower Control"
o o x o x x Go to "Problem Symptoms Table: Air Inlet Control"
o o o x x x Go to "Problem Symptoms Table: Air Outlet Control"
x x x x x x Air Conditioning Amplifier Assembly or Air Conditioning Assembly is Defective



AIR CONDITIONING CONTROL


Symptom Suspected Area Link
Air conditioning system cannot be operated using heater control assembly
·

No. 1 heater control sub-assembly

·

No. 2 heater control sub-assembly

·

No. 3 heater control sub-assembly


Click here
Air conditioning amplifier assembly Click here


COOLING FUNCTION


Symptom Suspected Area Link
No cool air comes out
(Blower control is normal)
·

Vehicle Control History (RoB)

·

Compressor with pulley assembly

·

Refrigerant pressure

·

Refrigerant volume

·

Cooler condenser assembly

·

Cooling fan system

·

No. 1 cooler thermistor

·

Air conditioner pressure sensor power source circuit

·

High inlet air temperature


Click here
Temperature control cable sub-assembly*1 Click here
Temperature control cable sub-assembly*2 Click here
No. 3 heater control sub-assembly circuit Click here
Harness or connector -
·

Cooling effectiveness is poor

·

Cooling response is slow


·

Compressor with pulley assembly

·

Refrigerant volume

·

Cooler condenser assembly

·

Cooling fan system

·

High inlet air temperature


Click here
Temperature control cable sub-assembly*1 Click here
Temperature control cable sub-assembly*2 Click here
No. 3 heater control sub-assembly circuit Click here
Harness or connector -

*1: for LHD

*2: for RHD



HEATER FUNCTION


Symptom Suspected Area Link
·

No warm air comes out

(Blower control is normal)

·

Outlet air temperature does not increase

(Blower control is normal)


·

Flow shutting valve

·

Engine coolant temperature

·

Blockage in heater radiator unit sub-assembly

·

Quick heater assembly*1

·

Heater radiator unit sub-assembly


Click here
Temperature control cable sub-assembly*2 Click here
Temperature control cable sub-assembly*3 Click here
No. 3 heater control sub-assembly circuit Click here
Harness or connector -
Heating performance is poor when it is cold*1
·

No. 2 semiconductor power integration ECU

·

Main body ECU (multiplex network body ECU)

·

Quick heater assembly

·

Air conditioning amplifier assembly

·

Harness and connector


Click here

*1: w/ PTC Heater

*2: for LHD

*3: for RHD



BLOWER CONTROL


Symptom Suspected Area Link
·

Blower motor does not operate at all

(Air does not blow from registers)

·

Airflow volume cannot be changed

·

Airflow volume is constantly low

·

Airflow volume sometimes becomes low


·

Power distribution box assembly

·

Blower motor with fan sub-assembly

·

Blower register

·

No. 2 heater control sub-assembly

·

Air conditioning amplifier assembly

·

Harness or connector


Click here


AIR INLET CONTROL


Symptom Suspected Area Link
Fresh/recirculation does not change*1
·

No. 1 blower damper servo sub-assembly

·

No. 2 heater control sub-assembly

·

Damper and damper link

·

Air conditioning harness assembly

·

Air conditioning amplifier assembly

·

Harness or connector


Click here
Fresh/recirculation does not change*2 Air inlet damper control cable sub-assembly*3 Click here
Air inlet damper control cable sub-assembly*4 Click here
No. 2 heater control sub-assembly Click here
Air conditioner unit assembly*3 Click here
Air conditioner unit assembly*4 Click here

*1: for Double Layer Type

*2: for Single Layer Type

*3: for LHD

*4: for RHD



AIR OUTLET CONTROL


Symptom Suspected Area Link
Air outlet mode cannot be changed Mode damper control cable sub-assembly*1 Click here
Mode damper control cable sub-assembly*2 Click here
No. 1 heater control sub-assembly Click here
Air conditioner unit*1 Click here
Air conditioner unit*2 Click here

*1: for LHD

*2: for RHD



DEFROSTER CONTROL


Symptom Suspected Area Link
Windshield frequently fogs up
·

Compressor with pulley assembly

·

Refrigerant volume

·

Cooler expansion valve

·

No. 1 heater control sub-assembly

·

Mode damper control cable sub-assembly

·

Air conditioning radiator assembly malfunction


Click here