Home › Vehicle Exterior › DOOR / HATCH › HOOD › from 2020.09
RM36W0E _59 Vehicle Exterior _088480 DOOR / HATCH _0421650 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B360727C03
0.656,0.24 0.969,0.396 0.313,0.156 10 false *a 2.469,0.24 2.781,0.396 0.313,0.156 10 false *b
*a Centering Bolt
*b Standard Bolt


HINT:
·

Centering bolts are used to install the hood hinges and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts with washers when making adjustments.

·

The specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 53301 1.INSPECT HOOD SUB-ASSEMBLY

Hide 53301 4.REMOVE HOOD SUB-ASSEMBLY

a.

Horizontally and vertically adjust the hood.

i.
B563077

Loosen the 4 hinge bolts of the hood.


ii.

Adjust the clearance between the hood and front fenders by moving the hood.


iii.

Tighten the 4 hinge bolts after adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.

Adjust the height of the front end of the hood using the hood bumper cushions.

i.
B563078

Adjust the 2 hood bumper cushions so that the heights of the hood and fenders are aligned.

HINT:

Raise or lower the front end of the hood by turning the 2 hood bumper cushions.




c.

Adjust the hood lock.

i.
B563079

Loosen the 3 bolts.


ii.

Adjust the hood lock assembly and tighten the 3 bolts.

Torque:
11.5 N*m (117 kgf*cm, 8 ft.*lbf)

NOTICE:

At the time of adjustment, use the supply hood lock assembly.



iii.

Check that the striker can engage the hood lock assembly smoothly.