Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Sedan)

ANTI-LOCK BRAKE SYSTEM (for Sedan) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


If no DTCs are displayed during the DTC check but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

NOTICE:
When replacing the brake actuator or sensor, turn the ignition switch off.


ANTI-LOCK BRAKE SYSTEM 
Symptom
Suspected Area
See page
ABS and/or EBD does not operate
1. Check for DTCs again and make sure that normal system code displayed.
Click here
2. IG power source circuit
Click here
3. Front speed sensor circuit
Click here
4. Skid control sensor circuit
Click here
5. Check brake actuator using intelligent tester. (Check brake actuator operation using active test function.) If abnormal, check hydraulic circuit for leakage.
Click here
6. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU).
Click here
ABS and/or EBD does not operate efficiently
1. Check for DTCs again and make sure that normal system code displayed.
Click here
2. Front speed sensor circuit
Click here
3. Skid control sensor circuit
Click here
4. Stop light switch circuit
Click here
5. Check brake actuator using intelligent tester. (Check brake actuator operation using active test function.) If abnormal, check hydraulic circuit for leakage.
Click here
6. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU).
Click here
Sensor signal check cannot be performed
1. TS and CG terminal circuit
Click here
2. Brake actuator (skid control ECU)
Click here
DTC check cannot be performed
1. Check for DTCs again and make sure that normal system code displayed.
Click here
2. TC and CG terminal circuit
Click here
3. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace brake actuator (skid control ECU).
Click here
ABS warning light remains on
1. ABS warning light circuit
Click here
2. Brake actuator (skid control ECU)
Click here
ABS warning light does not come on
1. ABS warning light circuit
Click here
2. Brake actuator (skid control ECU)
Click here
BRAKE warning light remains on
1. BRAKE warning light circuit
Click here
2. Brake actuator (skid control ECU)
Click here
BRAKE warning light does not come on
1. BRAKE warning light circuit
Click here
2. Brake actuator (skid control ECU)
Click here