Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › from 2015.08
RM19Y0E _57 Power Source / Network _003004 NETWORKING _0015181 CAN COMMUNICATION SYSTEM T

NETWORKING  CAN COMMUNICATION SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



Result List of How to Proceed with Troubleshooting
Symptom Suspected Area Link
The result of "How to Proceed with Troubleshooting" is "Open in CAN Main Bus Line". Open in CAN Main Bus Line (Includes DLC3 branch lines and terminating resistors) Click here
The result of "How to Proceed with Troubleshooting" is "Short in CAN Bus Lines". Short in CAN Bus Lines Click here
The result of "How to Proceed with Troubleshooting" is "Short to +B in CAN Bus Line". Short to +B in CAN Bus Line Click here
The result of "How to Proceed with Troubleshooting" is "Short to GND in CAN Bus Line". Short to GND in CAN Bus Line Click here
The result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line". Open in One Side of CAN Branch Line Click here

HINT:

Refer to How to Proceed with Troubleshooting for the V Bus Check procedure.


Communication Stop Mode Table
Symptom Suspected Area Link
"VSC/ABS" is not displayed on the GTS or Techstream. Skid Control ECU Communication Stop Mode Click here
"EPS" is not displayed on the GTS or Techstream. Power Steering ECU Communication Stop Mode Click here
"ECM (Engine)" is not displayed on the GTS or Techstream. ECM Communication Stop Mode Click here
"Main Body" is not displayed on the GTS or Techstream. Main Body ECU Communication Stop Mode Click here
"Combination Meter" is not displayed on the GTS or Techstream. Combination Meter ECU Communication Stop Mode Click here
"Airbag" is not displayed on the GTS or Techstream. Center Airbag Sensor Communication Stop Mode Click here
"Combination Switch" is not displayed on the GTS or Techstream. Combination Switch ECU Communication Stop Mode Click here

DTC Combination Table
Symptom Suspected Area Link
Although CAN communication (V bus) is currently normal, ECUs connected to the V bus store CAN communication DTCs. The probable part for which communication is interrupted can be determined using DTC Combination Table and comparing the DTCs output from ECUs connected to the CAN communication system. Click here