Inspect the fuses and bulbs for circuits related to this system before performing the following procedure.
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Body Electrical / Body / Active Test.
According to the display on the GTS or Techstream, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Dome lamp/room lamp | Map light assembly and No. 2 room light assembly | OFF/OFF, OFF/ON, ON/OFF, ON/ON | Turn the map light switch and No. 2 room light switch to the DOOR position. |
Each light comes on.
| Result | Proceed to |
|---|---|
| Active Test is abnormal (only map light assembly does not illuminate) | A |
| Active Test is abnormal (only No. 2 room light assembly does not illuminate) | B |
| Active Test is abnormal (not illuminate) | C |
| Active Test is normal (all lights illuminate) | D |
A
B
C
D
w/o Glass Case
Remove the map light assembly.
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT(w/o Glass Case)>REMOVAL
Inspect the map light assembly.
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT(w/o Glass Case)>INSPECTION
w/ Glass Case
Remove the map light assembly.
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT(w/ Glass Case)>REMOVAL
Inspect the map light assembly.
Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT(w/ Glass Case)>INSPECTION
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/o Glass Case) | B |
| NG (w/ Glass Case) | C |
A
B
C
w/o Intrusion Sensor
Remove the No. 2 room light assembly.
Click hereVehicle Interior>LIGHTING (INT)>ROOM LIGHT(w/o Intrusion Sensor)>REMOVAL
Inspect the No. 2 room light assembly.
Click hereVehicle Interior>LIGHTING (INT)>ROOM LIGHT(w/o Intrusion Sensor)>INSPECTION
w/ Intrusion Sensor
Remove the No. 2 room light assembly.
Click hereVehicle Interior>LIGHTING (INT)>ROOM LIGHT(w/ Intrusion Sensor)>REMOVAL
Inspect the No. 2 room light assembly.
Click hereVehicle Interior>LIGHTING (INT)>ROOM LIGHT(w/ Intrusion Sensor)>INSPECTION
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/o Intrusion Sensor) | B |
| NG (w/ Intrusion Sensor) | C |
A
B
C
Disconnect the 3E main body ECU (fuse block assembly) connector.
Disconnect the K1*1 or K4*2 map light assembly connector.
*1: w/o Glass Case
*2: w/ Glass Case
Disconnect the K2*1 or K5*2 No. 2 room light assembly connector.
*1: w/o Intrusion Sensor
*2: w/ Intrusion Sensor
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3E-17 - K1-3 (+) | Always | Below 1 Ω |
| 3E-16 - K1-2 (DR) | Always | Below 1 Ω |
| K1-1 (-) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3E-17 - K4-6 (+) | Always | Below 1 Ω |
| 3E-16 - K4-1 (DR) | Always | Below 1 Ω |
| K4-7 (-) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3E-17 - K2-2 (+) | Always | Below 1 Ω |
| 3E-16 - K2-1 (DR) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3E-17 - K5-4 (+B) | Always | Below 1 Ω |
| 3E-16 - K5-1 (CTL) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3E-17 or K1-3 (+) - Body ground | Always | 10 kΩ or higher |
| 3E-16 or K1-2 (DR) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3E-17 or K4-6 (+) - Body ground | Always | 10 kΩ or higher |
| 3E-16 or K4-1 (DR) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3E-17 or K2-2 (+) - Body ground | Always | 10 kΩ or higher |
| 3E-16 or K2-1 (DR) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3E-17 or K5-4 (+B) - Body ground | Always | 10 kΩ or higher |
| 3E-16 or K5-1 (CTL) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
|---|---|
| OK (for RHD) | A |
| OK (for LHD) | B |
| NG | C |
A
B
C