Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


If a normal system code is displayed during the DTC check, but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

HINT:
  1. The following is the troubleshooting procedure for the wireless door lock control of a vehicle without the entry and start system.
  2. Inspect the fuse and relay before investigating the suspected areas shown in the table below.
  3. Inspect each malfunction circuit in numerical order for its corresponding symptom.


WIRELESS DOOR LOCK CONTROL SYSTEM: 
Symptom
Suspected Area
See page
The wireless door lock control system does not operate.
1. Perform the operation check
Click here
2. Door control transmitter
Click here
3. Enter the self-diagnostic mode
Click here
4. If the recognition code does not match the key code, check that the key code can be registered in the rewrite or add mode of the recognition code registration
-
5. Unlock warning switch circuit
Click here
6. Door courtesy switch circuit
Click here
7. Luggage compartment door courtesy switch circuit
Click here
8. If the symptoms still occur after the above areas have been inspected and proved to be normal, replace the main body ECU (Instrument Panel J/B)
-
The automatic lock function does not operate normally.
1. Perform the operation check
Click here
2. Unlock warning switch circuit
Click here
3. Door courtesy switch circuit
Click here
4. If the symptoms still occur after the above areas have been inspected and proved to be normal, replace the main body ECU (Instrument Panel J/B)
-
The illuminated entry function only does not operate.
1. Perform the operation check
Click here
2. Lighting system
Click here
3. If the symptoms still occur after the above area has been inspected and proved to be normal, replace the main body ECU (Instrument Panel J/B)
-
The answer back function does not operate (Hazard warning light).
1. Perform the operation check
Click here
2. Lock position switch circuit
-
- Driver door
Click here
- Front passenger door
Click here
- Rear passenger door LH
Click here
- Rear passenger door RH
Click here
3. Wire harness
-
4. Turn signal flasher
Click here
5. If the symptoms still occur after the above areas have been inspected and proved to be normal, replace the main body ECU (Instrument Panel J/B)
-
The wireless trunk opener function only does not operate.
1. Perform the operation check
Click here
2. Unlock warning switch circuit
Click here
3. Luggage compartment door courtesy switch circuit
Click here
4. If the symptoms still occur after the above areas have been inspected and proved to be normal, replace the main body ECU (Instrument Panel J/B)
-