Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here



1. Headlight system: 
Symptom
Suspected area
See page
One side LO-beam headlight does not illuminate.
1. H-LP RL fuse or H-LP LL fuse
-
2. Bulb
-
3. Harness or connector
-
4. Light control ECU (for HID headlight)
-
5. Power distributor (Engine room J/B)
-
Both left and right LO-beam headlights do not illuminate.
1. H-LP RL fuse and H-LP LL fuse
-
2. Bulb
-
3. Light control switch circuit
Click here
4. Headlight relay circuit
Click here
5. Main body ECU (Instrument panel J/B)
-
One side HI-beam headlight does not illuminate.
1. H-LP RH fuse or H-LP LH fuse
-
2. Bulb
-
3. Harness or connector
-
4. Power distributor (Engine room J/B)
-
Both left and right HI-beam headlights do not illuminate.
1. H-LP RH fuse and H-LP LH fuse
-
2. Bulb
-
3. Light control switch circuit
Click here
4. Headlight (HI-BEAM) circuit
Click here
5. Main body ECU (Instrument panel J/B)
-
"Flash" headlight does not illuminate.
1. Light control switch circuit
Click here
2. Main body ECU (Instrument panel J/B)
-
LO-beam headlights or HI-beam headlights do not go off.
1. Headlight dimmer switch assembly
Click here
2. Power distributor (Engine room J/B)
-
3. Harness or connector
-
4. Main body ECU (Instrument panel J/B)
-

2. Taillight system: 
Symptom
Suspected area
See page
Front parking light does not illuminate.
1. Bulb
-
2. Harness or connector
-
Rear taillight does not illuminate.
1. Bulb
-
2. Harness or connector
-
License plate light does not illuminate.
1. Bulb
-
2. Harness or connector
-
Taillight system does not operate (Taillight, parking lights, and license plate lights do not illuminate).
1. TAIL fuse
-
2. Taillight relay
Click here
3. Light control switch circuit
Click here
4. Taillight relay circuit
Click here
5. Main body ECU (Instrument panel J/B)
-

3. Stop light system: 
Symptom
Suspected area
See page
Stop light system does not operate.
1. Bulb
-
2. Stop fuse
-
3. Stop light switch
Click here
4. Harness or connector
-
One side stop light does not illuminate.
1. Bulb
-
2. Harness or connector
-
Hi-mounted stop light does not illuminate.
1. Bulb
-
2. Harness or connector
-

4. Front fog light system: 
Symptom
Suspected area
See page
One side fog light does not illuminate.
1. Bulb
-
2. Harness or connector
-
Both left and right fog lights do not illuminate (Taillight system is normal).
1. FR FOG fuse
-
2. FR FOG relay
Click here
3. Light control switch circuit
Click here
4. Front fog light circuit
Click here
5. Main body ECU (Instrument panel J/B)
-

5. Rear fog light system: 
Symptom
Suspected area
See page
One side fog light does not illuminate.
1. Bulb
-
2. Harness or connector
-
Both left and right fog lights do not illuminate. (Taillight system is normal)
1. RR FOG fuse
-
2. RR FOG relay
Click here
3. Light control switch circuit
Click here
4. Rear fog light circuit
Click here
5. Main body ECU (Instrument panel J/B)
-

6. Turn signal and hazard warning system: 
Symptom
Suspected area
See page
Hazard warning lights do not operate (Turn signal lights are normal).
1. HAZ fuse
-
2. Hazard warning signal switch
Click here
3. Clock assembly
-
4. Turn signal flasher assembly
Click here
5. Harness or connector
-
Turn signal lights do not operate (Hazard warning lights are normal).
1. GAUGE No. 1 fuse
-
2. Headlight dimmer switch assembly (Turn signal switch)
Click here
3. Turn signal flasher assembly
Click here
4. Harness or connector
-
Hazard warning lights and turn signal lights do not operate.
1. HAZ fuse and GAUGE No. 1 fuse
-
2. Bulb
-
3. Turn signal flasher assembly
Click here
4. Hazard warning signal switch (Turn signal switch)
Click here
5. Headlight dimmer switch assembly
Click here
6. Clock assembly
-
7. Harness or connector
-
Turn signal lights do not operate in one direction.
1. Headlight dimmer switch assembly (Turn signal switch)
Click here
2. Turn signal flasher assembly
Click here
3. Harness or connector
-
Only one bulb does not operate.
1. Bulb
-
2. Harness or connector
-

7. Back-up light system: 
Symptom
Suspected area
See page
One side back-up light does not illuminate.
1. Bulb
-
2. Harness or connector
-
Both left and right back-up lights do not illuminate.
1. Bulb
-
2. GAUGE No. 1 fuse
-
3. Back-up light switch (for M/T)
Click here
4. Park/Neutral position switch (for U250E A/T)
Click here
5. Park/Neutral position switch (for U660E A/T)
Click here
6. Harness or connector
-

8. Illuminated entry system: 
Symptom
Suspected area
See page
Only interior light does not illuminate.
1. Bulb
-
2. Personal light assembly (with sliding roof)
Click here
3. Rear room light assembly (without sliding roof)
Click here
4. Harness or connector
-
Only ignition key cylinder light does not illuminate.
1. Transponder key amplifier (Ignition key cylinder light)
Click here
2. Harness or connector
-
Interior light and ignition key cylinder light do not operate normally.
1. DOME fuse
-
2. Personal light assembly
Click here
3. Rear room light assembly
Click here
4. Transponder key amplifier (Ignition key cylinder light)
Click here
5. Door courtesy switch circuit
Click here
6. Door lock position switch circuit
Click here
7. Ignition switch circuit
Click here
8. Interior light circuit
Click here
9. Main body ECU (Instrument panel J/B)
-

9. Vanity light system: 
Symptom
Suspected area
See page
Vanity light does not illuminate.
1. Bulb
-
2. Vanity light assembly
Click here
3. Visor assembly (Vanity light switch)
-
4. Harness or connector
-

10. Luggage compartment light system: 
Symptom
Suspected area
See page
Luggage compartment light does not illuminate.
1. Bulb
-
2. Luggage compartment light assembly
Click here
3. Luggage compartment door lock assembly (Door courtesy switch)
Click here
4. Harness or connector
-

11. Glove box light system: 
Symptom
Suspected area
See page
Glove box light does not illuminate.
1. Bulb
-
2. Glove box light assembly
Click here
3. Harness or connector
-

12. Door courtesy light system: 
Symptom
Suspected area
See page
Door courtesy light does not illuminate.
1. Bulb
-
1. Door courtesy light assembly
Click here
2. Door courtesy switch
-
3. Harness or connector
-

13. Personal light system: 
Symptom
Suspected area
See page
Front personal lights do not illuminate.
1. Bulb
-
2. Personal light assembly
Click here
3. Harness or connector
-
Rear personal lights do not illuminate.
1. Bulb
-
2. Rear room light assembly
Click here
3. Harness or connector
-

14. Automatic light control system: 
Symptom
Suspected area
See page
Automatic light control system does not operate normally.
1. Light control switch circuit
Click here
2. Automatic light control sensor circuit
Click here
3. Ignition switch circuit
Click here
4. Main body ECU (Instrument Panel J/B)
-

15. Light auto turn off system: 
Symptom
Suspected area
See page
Light auto turn off system does not operate normally.
1. Light control switch circuit
Click here
2. Door courtesy switch circuit
Click here
3. Main body ECU (Instrument Panel J/B)
-

16. Battery saving system: 
Symptom
Suspected area
See page
Battery saving function does not operate.
1. Door courtesy switch circuit
Click here
2. Main body ECU (Instrument Panel J/B)
-

17. Manual headlight beam level control system: 
Symptom
Suspected area
See page
Headlight beam level control does not operate.
1. Headlight leveling switch
Click here
2. Headlight leveling motor
-
3. Harness or connector
-

18. Automatic headlight beam level control system: 
Symptom
Suspected area
See page
Headlight beam level control warning light comes on.
1. Check the FAIL-SAFE function
Click here
2. Height control sensor circuit
Click here
3. Headlight beam level control warning circuit
Click here
4. Headlight beam level control ECU
-
Headlight beam level control does not operate (Warning light is off).
1. Check the FAIL-SAFE function
Click here
2. Headlight beam level control actuator circuit
Click here
3. Headlight signal circuit
Click here
4. Speed signal circuit
Click here
5. Headlight beam level control ECU power source circuit
Click here
6. Headlight leveling motor
-
7. Combination meter assembly
-
8. Headlight beam level control ECU
-
Headlight beam level warning light does not come on when turning the ignition switch to the ON position.
1. Headlight beam level warning circuit
Click here
2. Headlight beam level control ECU power source circuit
Click here
3. Headlight beam level control ECU
-
4. Combination meter assembly
-

NOTICE:
  1. Initialize the headlight beam level control ECU after the vehicle height changes due to replacement of the suspension or after performing such operations as removal and reinstallation or replacement of the rear height control sensor sub-assembly.
  2. When the headlight beam level control ECU is replaced, the initialization is also necessary.