Home › Drivetrain › EB62 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSAXLE SYSTEM › 2011.10–2013.07
RM19V0EQ _52 Drivetrain _014584 EB62 MANUAL TRANSMISSION / TRANSAXLE _0073995 MANUAL TRANSAXLE SYSTEM T

EB62 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Manual Transaxle System
Symptom Suspected Area Link
Abnormal noise Oil level (Low) Click here
Oil (Wrong) -
Clutch release with bearing cylinder assembly (Worn or damaged) Click here
Clutch disc (Worn or damaged)*1 Click here
Synchronizer ring (Input shaft) (Worn or damaged) Click here
Synchronizer ring (Output shaft) (Worn or damaged) Click here
Gear (Input shaft) (Worn or damaged) Click here
Gear (Output shaft) (Worn or damaged) Click here
Bearing (Input shaft) (Worn or damaged) Click here
Bearing (Output shaft) (Worn or damaged) Click here
Bearing (Differential case) (Worn or damaged) Click here
Oil leak Oil level (High) Click here
Gasket (Damaged) Click here
Oil seal (Worn or damaged) Click here
Clutch release with bearing cylinder assembly (Worn or damaged) Click here
Hard shifting or impossible to shift Oil (Wrong) -
Clutch (Dragging) Click here
Shift and select lever assembly (Worn or damaged) Click here
Control cable (Faulty) Click here
Shift fork (Input shaft) (Worn) Click here
Shift fork (Output shaft) (Worn) Click here
Synchronizer ring (Input shaft) (Worn or damaged) Click here
Synchronizer ring (Output shaft) (Worn or damaged) Click here
Shift key spring (Input shaft) (Worn or damaged) Click here
Shift key spring (Output shaft) (Worn or damaged) Click here
Gear (Input shaft) (Worn or damaged) Click here
Gear (Output shaft) (Worn or damaged) Click here
Hub sleeve (Input shaft) (Worn or damaged) Click here
Hub sleeve (Output shaft) (Worn or damaged) Click here
Jumps out of gear or shift lever moves excessively Shift fork (Input shaft) (Worn) Click here
Shift fork (Output shaft) (Worn) Click here
Hub sleeve (Input shaft) (Worn or damaged) Click here
Hub sleeve (Output shaft) (Worn or damaged) Click here
Gear (Input shaft) (Worn or damaged) Click here
Gear (Output shaft) (Worn or damaged) Click here
Bearing (Input shaft) (Worn or damaged) Click here
Bearing (Output shaft) (Worn or damaged) Click here

*1: If the clutch torsional damper springs are worn, they can produce a load-related noise similar to a bad bearing or gear rattle.