The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below.
*1: When the ECM is replaced with a new one, reset memory is unnecessary.
89615
1.REMOVE KNOCK CONTROL SENSOR
82219A
2.REMOVE SENSOR WIRE
Disengage the 2 clamps and remove the bolt and sensor wire.
19500
3.REMOVE IGNITION COIL ASSEMBLY
29300
4.REMOVE VACUUM PUMP ASSEMBLY
16267
5.REMOVE NO. 3 WATER BY-PASS HOSE
Slide the clip and remove the No. 3 water by-pass hose from the water inlet pipe.
16264
6.REMOVE NO. 2 WATER BY-PASS HOSE
Slide the clip and remove the No. 2 water by-pass hose from the water outlet.
12261
7.REMOVE VENTILATION HOSE
Slide the clip and remove the ventilation hose from the PCV valve (ventilation valve sub-assembly).
12262
8.REMOVE NO. 2 VENTILATION HOSE
Slide the clip and remove the No. 2 ventilation hose from the cylinder head cover sub-assembly.
16361A
9.REMOVE V-RIBBED BELT
27020
10.REMOVE GENERATOR ASSEMBLY
11.REMOVE COMPRESSOR ASSEMBLY WITH MAGNETIC CLUTCH
88431
12.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
Remove the 2 bolts and No. 1 compressor mounting bracket from the cylinder block sub-assembly.
16604
13.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
16620
14.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
Remove the 2 bolts and V-ribbed belt tensioner assembly.
16173
15.REMOVE WATER PUMP PULLEY
11452
16.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Remove the engine oil level dipstick from the engine oil level dipstick guide.
Remove the bolt and engine oil level dipstick guide from the camshaft housing sub-assembly LH and oil pan sub-assembly.
Remove the engine oil level dipstick guide O-ring from the engine oil level dipstick guide.
12585
17.REMOVE NO. 5 CYLINDER BLOCK INSULATOR (w/ Oil Cooler)
Remove the No. 5 cylinder block insulator from the engine assembly.
43457
18.REMOVE DRIVE SHAFT BEARING BRACKET
Remove the 3 bolts and drive shaft bearing bracket from the cylinder block sub-assembly.
19.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the bolt and wire harness clamp bracket from the camshaft housing sub-assembly LH.
Remove the bolt and wire harness clamp bracket from the camshaft housing sub-assembly.
16522
20.REMOVE WATER FILLER BRACKET
Remove the 2 bolts and water filler bracket from the camshaft housing sub-assembly LH.
12631A
21.REMOVE ENGINE COVER BRACKET
Remove the bolt and engine cover bracket from the cylinder head cover sub-assembly LH.