The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below.
11452
1.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Remove the engine oil level dipstick.
Remove the bolt and engine oil level dipstick guide.
Remove the O-ring from the engine oil level dipstick guide.
17118
2.REMOVE MANIFOLD STAY
17139
3.REMOVE NO. 2 MANIFOLD STAY
17167
4.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
25051
5.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (TWC: Front Catalyst)
16361A
6.REMOVE V-RIBBED BELT
27020
7.REMOVE GENERATOR ASSEMBLY
8.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the nut and wire harness clamp bracket.
Remove the bolt and wire harness clamp bracket.
Remove the bolt and wire harness clamp bracket.
88310
9.REMOVE COMPRESSOR ASSEMBLY WITH PULLEY
for Type A:
|
Bolt |
|
Nut |
Remove the 2 bolts and 2 nuts.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts.
for Type B:
Remove the 4 bolts.
Remove the compressor assembly with pulley.
43457
10.REMOVE DRIVE SHAFT BEARING BRACKET
Remove the 3 bolts and drive shaft bearing bracket.
88431
11.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
Remove the 4 bolts and No. 1 compressor mounting bracket.
22030
12.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
22271
13.REMOVE THROTTLE BODY GASKET
14.REMOVE WATER BY-PASS HOSE
Slide the 2 clips and remove the No. 2 water by-pass hose and No. 1 water by-pass hose.
17650
15.REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)
12262
16.DISCONNECT NO. 2 VENTILATION HOSE
23814B
17.REMOVE FUEL DELIVERY PIPE
23891
18.REMOVE FUEL DELIVERY SPACER
23291
19.REMOVE INJECTOR VIBRATION INSULATOR
23250
20.REMOVE FUEL INJECTOR ASSEMBLY
17111
21.REMOVE INTAKE MANIFOLD
82219A
22.REMOVE SENSOR WIRE
Disconnect the knock control sensor connector.
Remove the bolt and sensor wire from the cylinder block sub-assembly.
89615
23.REMOVE KNOCK CONTROL SENSOR
83530
24.REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
89422
25.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
19500
26.REMOVE IGNITION COIL ASSEMBLY