Home › Engine / Hybrid System › 14B (ENGINE MECHANICAL) › CYLINDER BLOCK › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073170 14B ENGINE MECHANICAL _0356054 CYLINDER BLOCK A

14B ENGINE MECHANICAL  CYLINDER BLOCK  AFTER ASSEMBLY  


PROCEDURE

Hide 1.INSTALL ENGINE MOUNTING BRACKETS

Torque:

44 N*m (449 kgf*cm, 32 ft.*lbf)


Hide 5.INSTALL OIL COOLER AND OIL FILTER ASSEMBLIES

Hide 6.INSTALL TIMING GEAR CASE (OIL PUMP), OIL STRAINER AND OIL PAN

Hide 10.INSTALL OIL DIPSTICK GUIDE AND OIL DIPSTICK (BU)

a.
A424186

Pull in the dipstick guide end into the guide hole of the cylinder block.


b.

Install the bolt as shown.


c.

Install the dipstick.


Hide 11.INSTALL WATER DRAIN UNION

a.

Apply seal packing to 2 or 3 threads.

Seal packing:

Toyota Genuine Seal Packing 1282B, Three Bond 1282B or equivalent



b.

Install the drain union.

Torque:

70 N*m (714 kgf*cm, 52 ft.*lbf)


HINT:

After applying the specified torque, rotate the drain union clockwise until its drain hole is facing downward.



Hide 13.INSTALL ALTERNATOR BRACKET AND ALTERNATOR

a.

Apply a light of engine oil on the threads and under the heads of the alternator bracket bolts and pivot bolt.


b.

Install the alternator bracket with the 3 bolts.

Torque:

98 N*m (1,000 kgf*cm, 72 ft.*lbf)



c.

Install the alternator with the pivot bolt.


Hide 14.DISCONNECT ENGINE FROM ENGINE STAND

Hide 11355 15.INSTALL REAR END PLATE

a.

w/11 inch flywheel:

Install the rear end plate with the bolt.

Torque:

18.5 N*m (189 kgf*cm, 14 ft.*lbf)



Hide 16.INSTALL FLYWHEEL HOUSING (w/12 INCH FLYWHEEL)

Hide 13405 17.INSTALL FLYWHEEL

a.

Install the flywheel on the crankshaft.


b.
A424187

Apply a light of engine oil on the threads and under the heads of the flywheel bolts.


c.

Install and uniformly tighten the bolts, in several passes, in the sequence shown.

Torque:

160 N*m (1,630 kgf*cm, 118 ft.*lbf)