Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
89174A
1.INSTALL FRONT AIRBAG SENSOR LH
Install the sensor with the bolt.
If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag sensor, make sure that the SRS wiring does not interfere with other parts and is not pinched between other parts.
Check that there is no free play in the installation parts of the sensor.
Connect the sensor connector.
2.INSTALL HEADLIGHT ASSEMBLY
except LED Headlight: (See page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(except LED Headlight)>INSTALLATION)
for LED Headlight: (See page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(for LED Headlight)>INSTALLATION)
52544
3.INSTALL FRONT BUMPER SIDE SEAL LH (for LED Headlight)
28800
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5.INSTALL FRONT BUMPER ASSEMBLY
for Standard: (See page Vehicle Interior>EXTERIOR>FRONT BUMPER(for Standard)>INSTALLATION)
for Sport Package: (See page Vehicle Interior>EXTERIOR>FRONT BUMPER(for Sport Package)>INSTALLATION)
6.INSPECT AND ADJUST HEADLIGHT AIMING
except LED Headlight: (See page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(except LED Headlight)>ADJUSTMENT)
for LED Headlight: (See page Vehicle Interior>LIGHTING>HEADLIGHT ASSEMBLY(for LED Headlight)>ADJUSTMENT)
7.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
8.CHECK SRS WARNING LIGHT
Check the SRS warning light (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).