2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE REAR BUMPER COVER
  1. for Standard:
    (Click here).

  1. w/ Towing Hitch:
    (Click here).

  1. w/ Pintle Hook:
    (Click here).


2. REMOVE NO. 2 FRAME WIRE
  1. for Standard:
    (Click here).

  1. w/ Towing Hitch:
    (Click here).

  1. w/ Pintle Hook:
    (Click here).


3. REMOVE NO. 1 ULTRASONIC SENSOR

  1. E244161
    Detach the 2 claws and remove the No. 1 ultrasonic sensor.

    HINT:
    1. Use the same procedure for all No. 1 ultrasonic sensors.
    2. The illustration shows the No. 1 ultrasonic sensor for the RH corner and back sensor LH and RH. The installation position of the No. 1 ultrasonic sensor for the LH corner is on the opposite side.


4. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER

  1. E244162
    Detach the 2 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper cover.

    HINT:
    1. Use the same procedure to remove the No. 1 ultrasonic sensor retainer on the other side.
    2. The illustration shows the No. 1 ultrasonic sensor retainer for the RH corner. The vertical orientation of the No. 1 ultrasonic sensor retainers for the LH corner is opposite that of the image shown in the illustration.


5. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER

  1. E244159
    Detach the 2 claws and remove the No. 2 ultrasonic sensor retainer from the rear bumper cover.

    HINT:
    Use the same procedure to remove the No. 2 ultrasonic sensor retainer on the other side.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →