PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| The result of "How to Proceed with Troubleshooting" is "Open in CAN Main Wire". |
Open in CAN Main Wire |
Click here
|
| The result of "How to Proceed with Troubleshooting" is "Short in CAN Bus Lines". |
Short in CAN Bus Lines |
Click here
|
| The result of "How to Proceed with Troubleshooting" is "Short to +B in CAN Bus Line". |
Short to B+ in CAN Bus Line |
Click here
|
| The result of "How to Proceed with Troubleshooting" is "Short to GND in CAN Bus Line". |
Short to GND in CAN Bus Line |
Click here
|
| The result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line". |
Open in One Side of CAN Branch Line |
Click here
|
| Symptom |
Suspected Area |
See page |
| "Air Conditioning Amplifier" not displayed on the intelligent tester. |
Air Conditioning Amplifier Communication Stop Mode |
Click here
|
| "CAN Gateway" not displayed on the intelligent tester. |
Gateway ECU Communication Stop Mode |
Click here
|
| "ECM (Engine)" not displayed on the intelligent tester. |
ECM Communication Stop Mode |
Click here
|
| "Main Body" not displayed on the intelligent tester. |
Main Body ECU Communication Stop Mode |
Click here
|
| "Combination Meter" not displayed on the intelligent tester. |
Combination Meter ECU Communication Stop Mode |
Click here
|
| "Airbag" not displayed on the intelligent tester. |
Center Airbag ECU Communication Stop Mode |
Click here
|
| "Display and Navigation (AVN)" not displayed on the intelligent tester. |
Display and Navigation Assembly Communication Stop Mode |
Click here
|