48826D
1.REMOVE STABILIZER CONTROL VALVE PROTECTOR
48860D
2.OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE
3.REMOVE REAR WHEEL
17430
4.REMOVE TAILPIPE ASSEMBLY
for 1GR-FE:
Remove the tailpipe (See page Engine / Hybrid System>1GR-FE (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL).
for 1UR-FE:
Remove the tailpipe (See page Engine / Hybrid System>1UR-FE (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL).
for 3UR-FE:
Remove the tailpipe (See page Engine / Hybrid System>3UR-FE (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL).
for 1VD-FTV:
Remove the tailpipe (See page Engine / Hybrid System>1VD-FTV (INTAKE / EXHAUST)>EXHAUST PIPE(w/o DPF)>REMOVAL).
17420
5.REMOVE EXHAUST CENTER PIPE ASSEMBLY
for 1GR-FE:
Remove the center exhaust pipe (See page Engine / Hybrid System>1GR-FE (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL).
for 1UR-FE:
Remove the center exhaust pipe (See page Engine / Hybrid System>1UR-FE (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL).
for 3UR-FE:
Remove the center exhaust pipe (See page Engine / Hybrid System>3UR-FE (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL).
for 1VD-FTV:
Remove the center exhaust pipe (See page Engine / Hybrid System>1VD-FTV (INTAKE / EXHAUST)>EXHAUST PIPE(w/o DPF)>REMOVAL).
6.DISCHARGE SUSPENSION FLUID PRESSURE
7.SUPPORT REAR AXLE HOUSING ASSEMBLY
48825A
8.REMOVE REAR STABILIZER END BRACKET
Remove the 2 bolts and disconnect the stabilizer end bracket.
48805
9.REMOVE REAR STABILIZER BAR SUB-ASSEMBLY
Remove the nut and disconnect the stabilizer link from the stabilizer bar.
Do not miss the ball joint dust cover protector.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
Remove the 4 bolts and stabilizer bar with the bushs and brackets.
48802
10.REMOVE STABILIZER LINK SUB-ASSEMBLY
Remove the nut, 3 retainers and 2 cushions, and disconnect the stabilizer link from the bracket.
Remove the nut, bolt and stabilizer link.
48884
11.REMOVE REAR STABILIZER CONTROL TUBE INSULATOR
Remove the 2 bolts and rear stabilizer control tube insulator.
48885
12.REMOVE REAR STABILIZER CONTROL CYLINDER
Remove the 2 union bolts with the 2 gaskets and bolt, and disconnect the stabilizer control tube.
Remove the bolt and stabilizer control cylinder.
48831
13.REMOVE REAR NO. 2 STABILIZER LINK
Remove the 2 bolts, 2 nuts and No. 2 rear stabilizer link.
48830
14.REMOVE REAR STABILIZER LINK ASSEMBLY
Remove the bolt, nut and rear stabilizer link.
49189C
15.REMOVE REAR SUSPENSION CONTROL BLEEDER PLUG
Remove the 2 rear suspension control bleeder plugs from the rear stabilizer control cylinder.