Home › Power Source / Network › 1UR-FE (BATTERY / CHARGING) › GENERATOR (for 130 A, 150 A Type)
RM2660E _57 Power Source / Network _052835 1UR-FE BATTERY / CHARGING _0255527 GENERATOR(for 130 A, 150 A Type) A

1UR-FE BATTERY / CHARGING  GENERATOR(for 130 A, 150 A Type)  REMOVAL  


PROCEDURE

Hide 2. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53806 4.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 5.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 51405A 6.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53782 8.REMOVE FRONT FENDER APRON TRIM PACKING A

Hide 44310 10.DISCONNECT VANE PUMP ASSEMBLY

Hide 27020 12.REMOVE GENERATOR ASSEMBLY

a.
A177892

Disconnect the generator connector.


b.

Open the terminal cap.


c.

Remove the nut and disconnect the generator wire.


d.

Remove the bolt and disconnect the wire harness bracket from the generator.


e.
A177893

Remove the 3 bolts, nut and generator.


f.

Remove the stud bolt.