Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU (for RHD) › 2014.08–2015.08
RM2660E _57 Power Source / Network _052837 NETWORKING _0255531 NETWORK GATEWAY ECU(for RHD) A

NETWORKING  NETWORK GATEWAY ECU(for RHD)  INSTALLATION  


PROCEDURE

Hide 89111 1.INSTALL NETWORK GATEWAY ECU

E154162

a.

Install the ECU with the bolt.


b.

Connect the connector.


Hide 73900 2.INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55303B 3.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

Hide 55432D 5.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 55606 6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55475A 7.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55474C 8.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55402C 9.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

a.

w/o Console Box Lid:

i.

Install the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Console Box Lid)>INSTALLATION).



b.

w/ Cool Box:

i.

Install the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>INSTALLATION).



c.

w/o Cool Box:

i.

Install the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Cool Box)>INSTALLATION).



Hide 55449C 10.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

a.

w/o Console Box Lid:

i.

Install the No. 2 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Console Box Lid)>INSTALLATION).



b.

w/ Cool Box:

i.

Install the No. 2 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>INSTALLATION).



c.

w/o Cool Box:

i.

Install the No. 2 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Cool Box)>INSTALLATION).



Hide 67913B 11.INSTALL FRONT DOOR SCUFF PLATE RH

a.

w/ Sliding Roof:

Install the front door scuff plate (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>INSTALLATION ).


b.

w/o Sliding Roof:

Install the front door scuff plate (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>INSTALLATION).


Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Driver Side Knee Airbag)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 13.CHECK SRS WARNING LIGHT (w/ Driver Side Knee Airbag)