Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU (for LHD) › 2014.08–2015.08
RM2660E _57 Power Source / Network _052837 NETWORKING _0255532 NETWORK GATEWAY ECU(for LHD) A

NETWORKING  NETWORK GATEWAY ECU(for LHD)  INSTALLATION  


PROCEDURE

Hide 89111 1.INSTALL NETWORK GATEWAY ECU

E154163

a.

Install the ECU with the nut.


b.

Connect the connector.


Hide 55433B 2.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 55476A 4.INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 73990 5.INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

Hide 55312 6.INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

Hide 55607 7.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55402C 8.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

a.

w/o Console Box Lid:

i.

Install the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Console Box Lid)>INSTALLATION).



b.

w/ Cool Box:

i.

Install the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>INSTALLATION).



c.

w/o Cool Box:

i.

Install the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Cool Box)>INSTALLATION).



Hide 55448A 9.INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

a.

w/o Console Box Lid:

i.

Install the No. 1 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Console Box Lid)>INSTALLATION).



b.

w/ Cool Box:

i.

Install the No. 1 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>INSTALLATION).



c.

w/o Cool Box:

i.

Install the No. 1 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Cool Box)>INSTALLATION).



Hide 67913B 10.INSTALL FRONT DOOR SCUFF PLATE RH

a.

w/ Sliding Roof:

Install the front door scuff plate (See pageVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>INSTALLATION ).


b.

w/o Sliding Roof:

Install the front door scuff plate (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>INSTALLATION).


Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Passenger Side Knee Airbag)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 12.CHECK SRS WARNING LIGHT (w/ Passenger Side Knee Airbag)