Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING SUPPORT BRAKE SYSTEM
RM37H0E _56 Audio / Visual / Telematics _095293 PARK ASSIST / MONITORING _0455112 PARKING SUPPORT BRAKE SYSTEM T

PARK ASSIST / MONITORING  PARKING SUPPORT BRAKE SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



General
Symptom Suspected Area Link
System does not operate at all TOYOTA parking assist-sensor system Click here
CAN communication system Click here
Clearance warning ECU assembly Click here
Blind spot monitor system Click here
Panoramic view monitor system* Click here

*: w/ Panoramic View Monitor System

Sonar Function
Symptom Suspected Area Link
Detection function operates when the operating conditions are not met Hybrid control system -
Brake actuator assembly (No. 2 skid control ECU) (for LHD) Click here
Brake actuator assembly (No. 2 skid control ECU) (for RHD) Click here
Clearance warning ECU assembly Click here
Detection function operates when vehicle is not within the required speed range (speedometer not malfunctioning) CAN communication system Click here
Clearance warning ECU assembly Click here

Buzzer Function
Symptom Suspected Area Link
Parking support brake system is normal but buzzer operation is intermittent Check that the temporary mute or auto mute function is not operating -
Proceed to "No. 1 Clearance Warning Buzzer Circuit" Click here
Proceed to "No. 2 Clearance Warning Buzzer Circuit" Click here
Proceed to "Buzzer does not Sound" Click here
Clearance warning ECU assembly Click here
Combination meter assembly Click here

Display Function
Symptom Suspected Area Link
While the parking support brake system is operating, no parking support brake notifications are displayed on the multi-information display. CAN communication system Click here
Clearance warning ECU assembly Click here
Combination meter assembly Click here
While the parking support brake system is operating, no parking support brake notifications are displayed on the headup display (meter mirror sub-assembly).* CAN communication system Click here
Clearance warning ECU assembly Click here
Meter mirror sub-assembly Click here
"Parking Support Brake Malfunction Visit Your Dealer" is displayed Combination meter assembly Click here
Clearance warning ECU assembly Click here
"Parking Support Brake Unavailable" is displayed Check that no foreign matter is attached to the ultrasonic sensors. -
CAN communication system Click here
Combination meter assembly Click here
Clearance warning ECU assembly Click here
Parking support brake system does not operate when there is a possibility of a collision (Warning message "Parking Support Brake Unavailable" not displayed) Check the installation of the ultrasonic sensors (front) Click here
Check the installation of the ultrasonic sensors (rear) Click here
Adjust the installation of the ultrasonic sensors as necessary. Click here
Ultrasonic sensors (front) Click here
Ultrasonic sensors (rear) Click here
Clearance warning ECU assembly Click here
Parking support brake system control operates when there is no possibility of a collision Check the installation of the ultrasonic sensors (front) Click here
Check the installation of the ultrasonic sensors (rear) Click here
Adjust the installation of the ultrasonic sensors as necessary. Click here
Ultrasonic sensors (front) Click here
Ultrasonic sensors (rear) Click here
Clearance warning ECU assembly Click here
Parking support brake system control cannot be turned off (PKSB OFF indicator does not illuminate) Meter/gauge system Click here
Steering pad switch assembly Click here
Clearance warning ECU assembly Click here
PKSB OFF indicator illuminate If "Yes" is displayed for the Data List item "BSM Radar Communication Invalid History", the blind spot monitor system may be malfunctioning. Click here
Check that no foreign matter is attached to the ultrasonic sensors. -

*: w/ Headup Display System