| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | PRECAUTION | - | ( )
|
- | - |
| 2 | SERVICE PLUG GRIP | G3834 | - | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 9 | EV SUPPLY BATTERY ASSEMBLY | G9510B | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 10 | UPPER EV BATTERY COVER PANEL | G92N1B | ( )
|
- | - |
| 11 | NO. 1 EV BATTERY SHIELD SUB-ASSEMBLY | G920QB | ( )
|
- | - |
| 12 | NO. 1 EV BATTERY JUNCTION BLOCK ASSEMBLY | G92Z0A | ( )
|
- | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during No. 1 EV battery junction block assembly removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>PRECAUTION
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
| Effect/Inoperative Function When Necessary Procedures are not Performed | Necessary Procedures | Link |
|---|---|---|
| Air conditioning system | After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. | - |
1. PRECAUTION
G3834
2.REMOVE SERVICE PLUG GRIP
53292A
3.REMOVE UPPER RADIATOR SUPPORT SEAL
1A906
4.REMOVE FC STACK COVER SUB-ASSEMBLY
G9510B
9.REMOVE EV SUPPLY BATTERY ASSEMBLY
G92Z0A
12.REMOVE NO. 1 EV BATTERY JUNCTION BLOCK ASSEMBLY
|
|
Disconnect the 4 connectors.
Insulate the disconnected connectors with insulating tape.
Remove the 4 nuts and No. 1 EV battery junction block assembly.
Do not drop the No. 1 EV battery junction block assembly, strike it with tools or subject it to impact.
If the No. 1 EV battery junction block assembly is subjected to an impact, replace it with a new one.