Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for TOYOTA Connect) › from 2021.08
RM37H0E _56 Audio / Visual / Telematics _095262 TELEMATICS _0484973 TELEMATICS SYSTEM(for TOYOTA Connect) T

TELEMATICS  TELEMATICS SYSTEM(for TOYOTA Connect)  PROBLEM SYMPTOMS TABLE  


NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for TOYOTA Connect.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for TOYOTA Connect)>PRECAUTION


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



TOYOTA Connect On-screen Message
Symptom Suspected Area Link
A message is temporarily displayed indicating to try again after waiting for a while because the lines are busy. This is caused when there is a problem with the radio wave signal conditions or when the base station is busy, but this is not a malfunction (Inform the customer that this is not a malfunction and ask them to use the system as is) -
A message is continuously displayed indicating to try again after waiting for a while because the lines are busy. Proceed to "Communication Access Failed" Click here
Proceed to "Telematics Transceiver Malfunction" Click here
A message is displayed indicating to try again after waiting for a while because information cannot be retrieved due to a busy line, etc. Wait for a while and perform the operation again in a different location -
Proceed to "Communication Access Failed" Click here
Proceed to "Telematics Transceiver Malfunction" Click here
A message is displayed indicating to try again after waiting for a while because information cannot be retrieved due to line disconnection. Proceed to "Communication Access Failed" Click here
Proceed to "Telematics Transceiver Malfunction" Click here
A message is displayed indicating to try again because information was not able to be retrieved. Proceed to "Communication Access Failed" Click here
Proceed to "Telematics Transceiver Malfunction" Click here
A message is displayed indicating to try again after waiting for a while because communication is being setup. The system is trying to detect the telematics transceiver. Wait for a while and perform the operation again. -
Proceed to "Telematics Transceiver Malfunction" Click here
A message is displayed indicating that TOYOTA Connect service is not available now as there is no response from the communication module. Proceed to "Telematics Transceiver Malfunction" Click here
A message is displayed indicating to move the vehicle into a communication service area as it is outside a service area. Wait for a while and perform the operation again in a different location (Within the communication service area) -
Proceed to "Communication Access Failed" Click here
Proceed to "Telematics Transceiver Malfunction" Click here
A message is displayed indicating that a cellular phone is not connected. Proceed to "Communication Access Failed" Click here
Proceed to "Telematics Transceiver Malfunction" Click here
A message is displayed indicating to move the vehicle to where a GPS signal can be received because the time data is old. Proceed to Problem Symptoms Table (GPS mark is not displayed) in Navigation System Click here
If the GPS mark is displayed, wait for a while and perform the operation again in a different location -
If the problem symptom is duplicated, replace the navigation ECU assembly Click here
A message is displayed indicating that TOYOTA Connect is not available as a microphone is not connected, which is required to use TOYOTA Connect. Proceed to "Microphone Circuit" in Navigation System Click here
A message is displayed indicating that bookmark registration failed. Navigation ECU assembly Click here
A message is displayed indicating that bookmark deletion failed. Navigation ECU assembly Click here
A message is displayed indicating that fixed phrase registration failed. Navigation ECU assembly Click here
A message is displayed indicating that fixed phrase deletion failed. Navigation ECU assembly Click here
A message is displayed indicating that this service is not available now. Proceed to "Telematics Service cannot be Used" Click here
A message is displayed indicating to ask the dealer about applying for the service as it is necessary to create a contract before using the service. Proceed to "Telematics Service cannot be Used" Click here
A message is displayed indicating that calls cannot be made due to restriction of outgoing calls. Wait for a while and perform the operation again because outgoing calls are restricted -

TOYOTA Connect Announcement Sound
Symptom Suspected Area Link
TOYOTA Connect announcement sound is not output. Adjust the volume (TOYOTA Connect announcement sound is not linked with the audio volume) -

Contract
Symptom Suspected Area Link
A message is displayed indicating to ask the dealer about applying for the service as it is necessary to create a contract before using the service. Fill in the vehicle contract setting request form and contact the TOYOTA Connect support center -
A message is displayed indicating to perform communication setting via TOYOTA Connect on the setting/editing screen as the communication settings of the cellular phone are required. As this message may be displayed when TOYOTA Connect is selected just after the cancellation procedure is completed, select TOYOTA Connect again after waiting for 6 minutes or more or after turning the ignition switch off -

Operator Service On-screen Message
Symptom Suspected Area Link
A message is displayed indicating to try again to use the operator service. Wait for a while and perform the operation again -
A message is displayed indicating to try again as the communication module is not connected. Proceed to "Telematics Transceiver Malfunction" Click here

Emergency Call Service Indicator Display Problem
Symptom Suspected Area Link
Illumination on the emergency call switch panel does not turn on. Proceed to "Emergency Call Switch Illumination Circuit" Click here
The red indicator light on the emergency call switch panel comes on after the ignition switch is turned to ON. The vehicle is outside the communication service area. Move the vehicle into a communication service area. -
The red indicator light on the emergency call switch panel blinks after the ignition switch is turned to ON. Check for DTCs -
Check for RoBs Click here
Perform a manual maintenance check. If it does not complete normally, refer to the symptom "The TOYOTA Connect Center cannot be accessed even after a manual maintenance check is performed" -
Turning the ignition switch to ON causes a manual maintenance check to start. Proceed to DTC B15C511 Click here

Emergency Call Service On-screen Message
Symptom Suspected Area Link
A message is displayed indicating that this service is not available now. Proceed to "Telematics Service cannot be Used" Click here
A message is displayed indicating to ask the dealer about applying for the service as it is necessary to create a contract before using the service. Proceed to "Telematics Service cannot be Used" Click here

Emergency Call Service Function
Symptom Suspected Area Link
The Toyota Connect center cannot be accessed even after a manual maintenance check is performed. Check that the Toyota Connect service is available -
Proceed to "Communication Access Failed" Click here
Proceed to "Telematics Transceiver Malfunction" Click here
The automatic maintenance check does not complete normally. Perform a manual maintenance check. If it does not complete normally, refer to the symptom "The Toyota Connect center cannot be accessed even after a manual maintenance check is performed". -
The Toyota Connect center cannot be accessed by pressing the emergency call switch. Perform a manual maintenance check. If it does not complete normally, refer to the symptom "The Toyota Connect center cannot be accessed even after a manual maintenance check is performed". -

My Request On-screen Message
Symptom Suspected Area Link
A message is displayed indicating that the service is not available now. Proceed to "Telematics Service cannot be Used" Click here
A message is displayed indicating to ask the dealer about applying for the service as it is necessary to create a contract before using the service. Proceed to "Telematics Service cannot be Used" Click here

Operator Service Function
Symptom Suspected Area Link
When using the operator service, the other caller's voice cannot be heard. Check if the navigation voice guidance is output normally. If not, refer to Navigation System. Click here
Proceed to "Received Voice Signal Circuit" Click here
When using the operator service, noise occurs in the transmitted voice (Caller's voice). Proceed to "Transmitted Voice Signal Circuit" Click here
When using the operator service, voice cannot be transmitted (The other caller cannot hear the caller's voice). Proceed to "Transmitted Voice Signal Circuit" Click here

Communication Based Voice Recognition Function
Symptom Suspected Area Link
Does not recognize voice commands performed to contact support center Check that the TOYOTA Connect service is available -
Check if the normal voice recognition function is operating correctly Click here
Proceed to "Does not Recognize Voice Commands Performed to Contact Support Center" Click here
Information content is not displayed Check that the TOYOTA Connect service is available -
Proceed to "Telematics Service cannot be Used" Click here

Home Appliance Linked Function
Symptom Suspected Area Link
The home appliance linked function cannot be operated by voice control. Check that the TOYOTA Connect service is available -
Check if the normal voice recognition function is operating correctly Click here
Proceed to "Does not Recognize Voice Commands Performed to Contact Support Center" Click here
Confirm Baidu registration -
Consult with "Baidu" -
Home appliance linked list is not displayed. Check that the TOYOTA Connect service is available -
Proceed to "Telematics Service cannot be Used" Click here
Confirm Baidu registration -
Consult with "Baidu" -

Remote Air Conditioning Function
Symptom Suspected Area Link
Air conditioning system does not start by remote air conditioning start function. Cancel service mode (communication function pausing mode) Click here
Check that the air conditioning system is operating normally -
Use the GTS to check whether the service subscription is active Click here
Proceed to "DCM Operation History" in Utility Click here