Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › 2014.11–2015.08
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301640 DYNAMIC RADAR CRUISE CONTROL SYSTEM T

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Dynamic Radar Cruise Control System
Symptom Suspected Area See page
The cruise control system cannot be turned on using the cruise control switch (ON-OFF button). Driving support ECU power source circuit (Click here)
Cruise control switch circuit (Click here)
Cruise main indicator light circuit (Click here)
Driving support ECU assembly (Click here)
Cannot change between vehicle-to-vehicle distance control mode and constant speed control mode. Cruise control switch circuit (Click here)
Combination meter sub-assembly (Click here)
Driving support ECU assembly (Click here)
Set distance cannot be changed. Distance control switch circuit (Click here)
Combination meter sub-assembly (Click here)
Driving support ECU assembly (Click here)
Cannot select vehicle-to-vehicle distance control mode. Combination meter sub-assembly (Click here)
Millimeter wave radar sensor assembly (Click here)
Driving support ECU assembly (Click here)
Vehicle speed setting cannot be performed. (The cruise control indicator light remains illuminated on the combination meter when cruise control system is turned on using the cruise control switch (ON-OFF button), but turns off when the SET function is operated.) Cruise control switch circuit (Click here)
Driving support ECU assembly (Click here)
Vehicle speed setting cannot be performed with constant speed control mode. (The cruise control indicator light remains illuminated on the combination meter when cruise control system is turned on using the cruise control switch (ON-OFF button), and remains on when the SET function is operated.) Stop light switch circuit (Click here)
Vehicle speed sensor circuit (Click here)
Cruise control switch circuit (Click here)
Hybrid control system (Click here)
Electronically controlled brake system (Click here)
Driving support ECU assembly (Click here)
Vehicle speed setting cannot be performed with vehicle-to-vehicle distance control mode. (The cruise control indicator light remains illuminated on the combination meter when cruise control system is turned on using the cruise control switch (ON-OFF button), and remains on when the SET function is operated.) Millimeter wave radar sensor assembly (Click here)
Stop light switch circuit (Click here)
Vehicle speed sensor circuit (Click here)
Cruise control switch circuit (Click here)
Hybrid control system (Click here)
Wiper signal circuit (Click here)
Electronically controlled brake system (Click here)
Driving support ECU assembly (Click here)
While vehicle is driven with the cruise control system controlling vehicle speed, the control of vehicle speed is canceled. Stop light switch circuit (Click here)
Hybrid control system (Click here)
Electronically controlled brake system (Click here)
Cruise control switch circuit (Click here)
Combination meter sub-assembly (Click here)
Vehicle speed sensor circuit (Click here)
Wiper signal circuit (Click here)
Driving support ECU assembly (Click here)
Pulling back on the cruise control switch does not cancel vehicle speed control by the cruise control system. (The cruise control indicator light remains illuminated.) Cruise control switch circuit (Click here)
Combination meter sub-assembly (Click here)
Driving support ECU assembly (Click here)
Pulling back on the cruise control switch does not cancel vehicle speed control by the cruise control system. (The vehicle-to-vehicle cruise control indicator light goes out.) Driving support ECU assembly (Click here)
Vehicle speed control by the cruise control system is not canceled when vehicle speed drops below the low speed limit. (The cruise control indicator light remains illuminated.) Vehicle speed sensor circuit (Click here)
Combination meter sub-assembly (Click here)
Driving support ECU assembly (Click here)
Vehicle speed control by the cruise control system is not canceled when vehicle speed drops below the low speed limit. (The vehicle-to-vehicle cruise control indicator light goes out.) Driving support ECU assembly (Click here)
Depressing the brake pedal does not cancel vehicle speed control by the cruise control system. (The cruise control indicator light remains illuminated.) Stop light switch circuit (Click here)
Combination meter sub-assembly (Click here)
Driving support ECU assembly (Click here)
Depressing the brake pedal does not cancel vehicle speed control by the cruise control system. (The vehicle-to-vehicle cruise control indicator light goes out.) Driving support ECU assembly (Click here)
Vehicle speed control by the cruise control system is not canceled when the wipers operate on HI. (The cruise control indicator light remains illuminated.) Wiper signal circuit (Click here)
Combination meter sub-assembly (Click here)
Driving support ECU assembly (Click here)
Vehicle speed control by the cruise control system is not canceled when the wipers operate on HI. (The vehicle-to-vehicle cruise control indicator light goes out.) Driving support ECU assembly (Click here)
Moving the shift lever does not cancel vehicle speed control by the cruise control system. (The cruise control indicator light remains illuminated.) Hybrid control system (Click here)
Combination meter sub-assembly (Click here)
Driving support ECU assembly (Click here)
Moving the shift lever does not cancel vehicle speed control by the cruise control system. (The vehicle-to-vehicle cruise control indicator light goes out.) Driving support ECU assembly (Click here)
Hunting (Speed is not constant.) Vehicle speed sensor circuit (Click here)
SFI system (Click here)
Hybrid control system (Click here)
Driving support ECU assembly (Click here)
Even though the front millimeter wave radar sensor is not dirty, "E2" is displayed. Millimeter wave radar sensor assembly is dirty -
Adjust front millimeter wave radar sensor assembly (Click here)
Millimeter wave radar sensor assembly (Click here)
The beam axis of the millimeter wave radar sensor cannot be adjusted. Check position, distance and angle of reflector (Click here)
Check installation of millimeter wave radar sensor assembly (Click here)
Millimeter wave radar sensor assembly (Click here)
Driving support ECU assembly (Click here)
The warning buzzer does not sound. Skid control buzzer circuit (Click here)
Millimeter wave radar sensor assembly (Click here)
Driving support ECU assembly (Click here)
No brake control (when decelerating) Electronically controlled brake system (Click here)
Driving support ECU assembly (Click here)
The cruise control SET indicator light does not illuminate. (Vehicle speed can be set) Cruise control SET indicator light circuit (Click here)