The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during HV battery junction block assembly removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
G3834
2.REMOVE SERVICE PLUG GRIP
82111
3.DISCONNECT ENGINE ROOM MAIN WIRE
4.REMOVE CONNECTOR COVER ASSEMBLY
5.CHECK TERMINAL VOLTAGE
6.INSTALL CONNECTOR COVER ASSEMBLY
82111
7.CONNECT ENGINE ROOM MAIN WIRE
8.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
72693
9.REMOVE REAR SEAT CUSHION LOCK HOOK
899A0
10.REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
67918E
11.REMOVE REAR DOOR SCUFF PLATE LH
58467H
12.REMOVE NO. 3 BATTERY SERVICE COVER BOARD
67917C
13.REMOVE REAR DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
58466J
14.REMOVE NO. 2 BATTERY SERVICE COVER BOARD
58464D
15.REMOVE BATTERY SERVICE COVER BOARD
71033
16.REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
G92N4A
17.REMOVE NO. 1 HV BATTERY COVER PANEL RH
821H1
18.DISCONNECT FLOOR UNDER WIRE
82161
19.DISCONNECT FLOOR WIRE
Be sure to wear insulated gloves.
| *a | Electric Vehicle Battery Plug Assembly Connector |
| *b | HV Battery Junction Block Assembly Connector |
Disengage the clamp.
Disconnect the electric vehicle battery plug assembly connector.
Disconnect the HV battery junction block assembly connector.
Disengage the 2 clamps to disconnect the floor wire.
G92F1
20.REMOVE NO. 1 HYBRID BATTERY EXHAUST DUCT
G920NB
21.REMOVE UPPER HV BATTERY COVER SUB-ASSEMBLY
G92Z0
22.REMOVE HV BATTERY JUNCTION BLOCK ASSEMBLY
Be sure to wear insulated gloves and protective goggles.
Remove the bolt and disconnect the electric vehicle battery plug assembly.
Disconnect the HV battery junction block assembly connector.
Insulate the disconnected connectors with insulating tape.
Disengage the clamp.
Disengage the 2 claws and open the wiring harness protector.
Disconnect the HV battery junction block assembly connector.
Insulate the disconnected connectors with insulating tape.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the wiring harness protector.
Disconnect the HV battery junction block assembly connector.
Remove the 4 nuts and HV battery junction block assembly from the HV battery.
If the HV battery junction block assembly has been struck or dropped, replace it with a new one.