Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1.RELEASE PARKING BRAKE
for Manual Transaxle: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>REMOVAL
except Manual Transaxle: Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>REMOVAL
2.DISABLE BRAKE CONTROL (w/o Vacuum Brake Booster)
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
3.REMOVE REAR WHEEL
890C0A
4.DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
5.DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH
for 2WD: Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE CARRIER (for 2WD)>REMOVAL
for 4WD/AWD: Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE CARRIER (for 4WD/AWD)>REMOVAL
42431
6.REMOVE REAR DISC
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
7.INSPECT REAR AXLE HUB BEARING LOOSENESS
Using a dial indicator, check for looseness near the center of the rear axle hub.
0.05 mm (0.00197 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.
If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.
8.INSPECT REAR AXLE HUB RUNOUT
Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.
0.05 mm (0.00197 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Make sure to install the tip of the dial indicator towards the outside of the rear axle hub bolts.
Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.
If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.
42431
9.INSTALL REAR DISC
10.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
for 2WD: Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE CARRIER (for 2WD)>INSTALLATION
for 4WD/AWD: Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE CARRIER (for 4WD/AWD)>INSTALLATION
890C0A
11.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
12.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (w/o Vacuum Brake Booster)
Connect the reservoir level switch connector.
Connect the cable to the negative (-) auxiliary battery terminal.
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>INSTALLATION
Perform the following procedure if air bleeding is not necessary:
Turn the power switch on (READY).
Depress the brake pedal and release it.
13.INSTALL REAR WHEEL