1.INSPECT REAR SEAT OUTER BELT ASSEMBLY
73370E
2.INSTALL REAR SEAT OUTER BELT ASSEMBLY LH
Attach the guide to install the rear seat outer belt assembly LH to the outer belt anchor bracket sub-assembly LH.
Temporarily install the nut.
|
Bolt |
|
Nut |
Attach the guide to temporarily install the rear seat outer belt assembly LH with bracket.
Temporarily install the 2 bolts.
Tighten the 2 bolts in the order shown in the illustration.
Tighten the nut.
| *a | Locking Button |
|
Install in this Direction |
w/ Pretensioner and Force Limiter:
Connect the pretensioner connector and lock the locking button as shown in the illustration.
When handling the pretensioner connector, take care not to damage the pretensioner wire harness.
Securely lock the locking button.
| *a | Protruding Part |
Install the floor anchor of the rear seat outer belt assembly LH with the bolt.
Be sure to install the floor anchor of the rear seat outer belt assembly LH in parallel with upper and lower protruding part.
Check that the ELR locks.
With the rear seat outer belt assembly LH installed to the vehicle, check that the belt locks when it is pulled out quickly.
73360D
3.INSTALL REAR SEAT OUTER BELT ASSEMBLY RH
Attach the guide to install the rear seat outer belt assembly RH to the outer belt anchor bracket sub-assembly RH.
Temporarily install the nut.
| *a | Locking Button |
|
Install in this Direction |
w/ Pretensioner and Force Limiter:
Connect the pretensioner connector and lock the locking button as shown in the illustration.
When handling the pretensioner connector, take care not to damage the pretensioner wire harness.
Securely lock the locking button.
|
Bolt |
|
Nut |
Attach the guide to temporarily install the rear seat outer belt assembly RH with bracket.
Temporarily install the 2 bolts.
Tighten the 2 bolts in the order shown in the illustration.
Tighten the nut.
| *a | Protruding Part |
Install the floor anchor of the rear seat outer belt assembly RH with the bolt.
Be sure to install the floor anchor of the rear seat outer belt assembly RH in parallel with upper and lower protruding part.
Check that the ELR locks.
With the rear seat outer belt assembly RH installed to the vehicle, check that the belt locks when it is pulled out quickly.
62480A
4.INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH
62470A
5.INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH
Use the same procedure described for the LH side.
64740E
6.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
64730J
7.INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
58460D
8.INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY
73708A
9.INSTALL TETHER ANCHOR BRACKET SET
62552F
10.INSTALL REAR SEAT SIDE GARNISH LH
62551F
11.INSTALL REAR SEAT SIDE GARNISH RH
Use the same procedure described for the LH side.
62332C
12.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
62331C
13.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
Use the same procedure described for the LH side.
58577E
14.INSTALL REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE
58464D
15.INSTALL BATTERY SERVICE COVER BOARD (for HV Model)
58466J
16.INSTALL NO. 2 BATTERY SERVICE COVER BOARD (for HV Model)
58467H
17.INSTALL NO. 3 BATTERY SERVICE COVER BOARD (for HV Model)
67918E
18.INSTALL REAR DOOR SCUFF PLATE LH
67917C
19.INSTALL REAR DOOR SCUFF PLATE RH
Use the same procedure described for the LH side.
73706
20.INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH
73705
21.INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
71304C
22.INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY LH
71303C
23.INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
24.INSTALL REAR SEATBACK ASSEMBLY RH
73350C
25.INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY (FLOOR ANCHOR)
26.INSTALL REAR SEATBACK ASSEMBLY LH
72693
27.INSTALL REAR SEAT CUSHION LOCK HOOK
28.INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
29.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for A25A-FKS:
for M20A-FKS:
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
65351A
30.INSTALL BATTERY HOLE COVER (for HV Model)
58386
31.INSTALL REAR FLOOR FINISH PLATE
64993
32.INSTALL REAR DECK FLOOR BOX (w/o Spare Tire)
58417H
33.INSTALL REAR NO. 3 FLOOR BOARD
58416K
34.INSTALL REAR NO. 2 FLOOR BOARD
58410B
35.INSTALL DECK BOARD ASSEMBLY
64910N
36.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
37.INSPECT SEAT HEATER SYSTEM (w/ Seat Heater System)
38. PERFORM DIAGNOSTIC SYSTEM CHECK
for HV Model with Occupant Classification System:
for Gasoline Model with Occupant Classification System:
w/o Occupant Classification System:
39.CHECK SRS WARNING LIGHT
for HV Model with Occupant Classification System:
for Gasoline Model with Occupant Classification System:
w/o Occupant Classification System:
40.INSPECT SEAT BELT WARNING SYSTEM
w/ Occupant Classification System:
w/o Occupant Classification System: