88240A
1.INSTALL DISTANCE CONTROL ECU ASSEMBLY
Install the distance control ECU with the bolt.
Do not install the distance control ECU assembly if it has been damaged or received some sort of shock.
Connect the connector.
82733A
2.INSTALL MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
73900
3.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
55046A
4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
53601
5.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55318C
6.INSTALL INSTRUMENT SIDE PANEL LH
62312B
7.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62112
8.INSTALL COWL SIDE TRIM BOARD LH
67914
9.INSTALL FRONT DOOR SCUFF PLATE LH
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
11.INSPECT SRS WARNING LIGHT
Inspect the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).
12.INITIALIZE DISTANCE CONTROL ECU
Initialize the distance control ECU (See page Engine / Hybrid System>CRUISE CONTROL>DYNAMIC LASER CRUISE CONTROL SYSTEM>INITIALIZATION).