Home › Vehicle Interior › HEATING / AIR CONDITIONING › B48 COMPRESSOR
RM3650E _58 Vehicle Interior _079885 HEATING / AIR CONDITIONING _0387590 B48 COMPRESSOR A

HEATING / AIR CONDITIONING  B48 COMPRESSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Refrigerant circuit under high pressure.

Danger of injury.

-

Note and follow safety information on containers.

-

Avoid contact with refrigerant; wear safety goggles and protective gloves.

-

For more information see:





NOTICE:
·

External damage to compressor with pulley assembly.

Excessive force applied during removal will result in damage to the compressor with pulley assembly.

-

Remove the compressor with pulley assembly without damaging it and without applying external force.

-

Avoid impacts/knocks to plastic belt pulley (caused by tools, contact with base).




HINT:

If mechanical failure of the compressor with pulley assembly occurs resulting in chips entering the refrigerant circuit, replace the following parts: compressor with pulley assembly, cooler condenser assembly with desiccant insert, line to cooler condenser assembly and compressor oil.


PROCEDURE

Hide 1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 4.REMOVE FAN AND GENERATOR V BELT

Hide 8.REMOVE COMPRESSOR WITH PULLEY ASSEMBLY

CAUTION:
·

Danger of injury.

-

Wear safety goggles and protective gloves when disconnecting the refrigerant line.

-

Seal refrigerant lines with seal plugs.




a.
I114304

Remove the T45 bolt (1) to disconnect the suction pipe sub-assembly from the compressor with pulley assembly (3).


b.

Remove the T45 bolt (1) to disconnect the discharge tube G from the compressor with pulley assembly (3).


c.

Remove the O-rings.


d.

Disconnect connector (2).


e.
I114303

Remove E12 bolts (1).


f.

Remove the compressor with pulley assembly (2) from the function carrier and secure it from falling.