Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING UNIT (for LHD)
RM3650E _58 Vehicle Interior _079885 HEATING / AIR CONDITIONING _0387587 AIR CONDITIONING UNIT(for LHD) N

HEATING / AIR CONDITIONING  AIR CONDITIONING UNIT(for LHD)  ON-VEHICLE CLEANING  


CAUTION / NOTICE / HINT

CAUTION:
·
B475753

Airbag unit.

Danger of life-threatening injuries.

-

Work on pyrotechnic parts may only be carried out by competent and properly trained persons.

-

Replace damaged or fallen parts.

-

Disconnect the battery lead from the battery before carrying out any work on the airbag.

-

Only lay the airbag unit with the upholstery (airbag) facing upwards.

-

For further information see: Safety instructions for handling components with gas generators.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION




NOTICE:
·

Damage to the air conditioning.

The use of a non-approved clean air filter can lead to functional impairment of the air conditioner.

-

Only operate the air conditioner with the prescribed clean air filter.




HINT:

Air conditioning is set to recirculation mode.


PROCEDURE

Hide 55011A 2.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55550 3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 87139C 4.REMOVE CLEAN AIR FILTER

Hide 73900 5.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

Hide 87103B 6.REMOVE BLOWER WITH FAN MOTOR SUB-ASSEMBLY

Hide 88501 7.CLEAN NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

CAUTION:
·

Health impairment in contact with liquids.

-

Observe safety instructions on the containers and comply with them.

-

Only carry out work with appropriate personal protective equipment.




HINT:

Park the vehicle at a suitable washing area, as the effluent cleaning agent escapes through the condensation drain on the transmission tunnel.


a.

Fill the cleaner in special tool 9 429 217.

SST
09800-WA190  

Cleaner:

Air Conditioning System Cleaner



b.

Connect special tool 2 222 502 with special tool 9 429 217.

SST
09800-WA250  09800-WA190  


c.

Build pressure in special tool 9 429 217.


d.

Close all ventilation vents.


e.

Cover the carpet in the work area.


f.
I114834

Insert special tool 2 222 502 into the opening of the housing as shown.

SST
09800-WA250  


g.
I114835

Move the special tool 2 222 502 in the opening of the housing in the directions of the arrows from the lower edge (1) to the upper edge (2).

SST
09800-WA250  


h.

Move special tool 2 222 502 back and forth until the cleaner has been completely sprayed.

SST
09800-WA250  


i.

After cleaning, drain vehicle for approx. 5 minutes.


Hide 87103B 8.INSTALL BLOWER WITH FAN MOTOR SUB-ASSEMBLY

Hide 73900 9.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

Hide 87139C 10.INSTALL CLEAN AIR FILTER

Hide 55550 11.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55011A 12.INSTALL NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY