Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


Check the suspected areas for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

HINT:
Inspect the fuses and relays before inspecting the suspected areas shown in the table below.
If the malfunction still exists even after checking and confirming that all the suspected areas are normal, replace the A/C amplifier.


Symptom
Suspected area
See page
No Cool Air Comes Out:
  1. Compressor Not Operating
A/C fuse
-
Volume of refrigerant
Click here
Pressure switch
Click here
Magnetic clutch
Click here
Cooler thermistor sensor
Click here
Air conditioner amplifier assembly
Click here
Compressor pick up sensor
Click here
Cooler compressor
Click here
Cooler compressor
Click here
Wire harness or connector
-
No Cool Air Comes Out:
  1. Blower Not Operating
HTR fuse
-
Heater relay
Click here
Blower resistor
Click here
Blower motor
Click here
Blower speed control switch
Click here
Air conditioning control assembly
Click here
Wire harness or connector
-
No Cool Air Comes Out:
  1. Air Mix Damper Servo Not Operating
Air mix damper fuse
-
Air mix control servo motor
Click here
Air conditioning control assembly
Click here
Wire harness or connector
-
No Cool Air Comes Out:
  1. Insufficient Cooling
Volume of refrigerant
Click here
Blower motor performance check
-
Air mix damper servo full travel check
-
Recirculation damper servo operation check
-
No Engine Idle-up when A/C Switch ON
Air conditioner amplifier assembly
Click here
Idling control system (2TR-FE)
Click here
Idling control system (1GR-FE)
Click here
Wire harness or connector
-
No Warm Air Comes Out:
  1. Blower Not Operating
HTR fuse
-
Heater relay
Click here
Blower resistor
Click here
Blower motor
Click here
Blower speed control switch
Click here
Air conditioning control assembly
Click here
Wire harness or connector
-
No Warm Air Comes Out:
  1. Air Mix Damper Servo Not Operating
Air mix damper fuse
-
Air mix control servo motor
Click here
Air conditioning control assembly
Click here
Wire harness or connector
-
No Warm Air Comes Out:
  1. Insufficient Cooling
Volume of engine coolant
-
Air conditioning control assembly
Click here
Blower motor performance check
-
Air mix damper servo full travel check
-
Recirculation damper servo operation check
-
Heater radiator
-
Air Not Coming From Desired Outlets:
  1. Blower Not Operating
HTR fuse
-
Heater relay
Click here
Blower resistor
Click here
Blower motor
Click here
Blower speed control switch
Click here
Air conditioning control assembly
Click here
Wire harness or connector
-
Air Not Coming From Desired Outlets:
  1. Air Mix Damper Servo Not Operating
Air mix damper fuse
-
Air mix control servo motor
Click here
Air conditioning control assembly
Click here
Wire harness or connector
-
Windshield Fogging:
  1. Compressor Not Operating
A/C fuse
-
Volume of refrigerant
Click here
Pressure switch
Click here
Magnetic clutch
Click here
Cooler thermistor sensor
Click here
Air conditioner amplifier assembly
Click here
Compressor pick up sensor
Click here
Cooler compressor
Click here
Cooler compressor
Click here
Wire harness or connector
-
Windshield Fogging:
  1. Blower Not Operating
HTR fuse
-
Heater relay
Click here
Blower resistor
Click here
Blower motor
Click here
Blower speed control switch
Click here
Air conditioning control assembly
Click here
Wire harness or connector
-
Windshield Fogging:
  1. Air Mix Damper Servo Not Operating
Air mix damper fuse
-
Air mix control servo motor
Click here
Air conditioning control assembly
Click here
Wire harness or connector
-
Windshield Fogging:
  1. Insufficient Cooling
Volume of refrigerant
Click here
Blower motor performance check
-
Air mix damper servo full travel check
-
Recirculation damper servo operation check
-
Defrosting Insufficient:
  1. Air flow from def outlet insufficient (Check airflow when engine is running, blower MAX and DEF mode)
Blower motor
Click here
Mode doors: Check cooling, heating & door operation
-
Mode control servo motor: Hot air not coming, Go to no hot air comes out
-
Mode control servo motor: Cold air not coming, Go to no cold air comes out
-
Noise:
  1. Blower noise (Check noise when ignition switch ON and blower ON)
Blower motor: Inspect blower motor for debris/cracks
-
Fresh air intake area: Inspect fresh air intake area for debris
-
Noise:
  1. A/C system (Engine is running, A/C switch is ON. Detect noise source using soundscope and moving around the refrigerant system.)
Cooler compressor: Cooler compressor incorrectly fitted
Click here
Magnetic clutch
Click here
Refrigerant charge amount
Click here
Compressor mounting bracket: Compressor mounting bracket incorrectly fitted (2TR-FE)
Click here
Compressor mounting bracket: Compressor mounting bracket incorrectly fitted (1GR-FE (2WD))
Click here
Compressor mounting bracket: Compressor mounting bracket incorrectly fitted (1GR-FE (PRE RUNNER/4WD))
Click here
A/C lines secure & not grounded
-
Odor (Cycle through blower speed, mode, temperature to define odor type when engine is running and A/C switch is ON. (Musty smell, coolant oil smell))
Wet carpet: Inspect water, engine coolant or oil leaks
-
A/C drain tube: Inspect water, engine coolant or oil leaks
-
Fresh air intake area: Inspect water, engine coolant or oil leaks
-
Heater hose: Inspect water, engine coolant or oil leaks
-
Evaporator: Inspect water, engine coolant or oil leaks
-
Evapo case: Inspect water, engine coolant or oil leaks
-
Air Not Coming from Desired Outlets (Cycle the mode lever and check airflow for outlets when engine is running, A/C switch is ON.)
Blower motor
Click here
Mode control servo motor
Click here
Mode doors: Check cooling, heating & door operation
-
Wire harness or connector
-
Air conditioning control assembly
Click here