Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › from 2017.01
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0309752 AUTOMATIC HIGH BEAM SYSTEM T

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

When replacing the pre-crash safety city sensor, replace it with a new one and be sure to initialize the settings. If a pre-crash safety city sensor which was installed to another vehicle is used, the information stored in the pre-crash safety city sensor will not match the information from the vehicle and, as a result, a DTC may be stored.

·

If the pre-crash safety city sensor has been replaced, or the windshield glass has been replaced or removed/installed, be sure to perform Pre-crash Safety City Sensor Learning.

Perform adjustment using One Time Recognition or Sequential Recognition.

One Time Recognition: Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (ONE TIME RECOGNITION)

Sequential Recognition: Click hereVehicle Interior>PRE-CRASH SAFETY>FRONT SENSOR>ADJUSTMENT (SEQUENTIAL RECOGNITION)



HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Automatic High Beam System
Symptom Suspected Area Click here
LED indicator of the pre-crash safety city sensor does not illuminate Pre-crash safety city sensor (Click here)
Harness and connector -
LED indicator remains on or blinks even if the AUTO switch the of pre-crash safety city sensor is operated Pre-crash safety city sensor (Click here)
Automatic high beam indicator light does not illuminate in green (automatic high beam system operates) Check operation condition (Click here)
Check meter / gauge system (Click here)
Pre-crash safety city sensor (Click here)
Main body ECU (multiplex network body ECU) (Click here)
Automatic high beam system does not operate Pre-crash safety System Circuit (Click here)
Check for DTCs (Click here)
Check illumination condition of low and high beam headlights using manual operation -
Data List (check auto high beam sensor condition)* (Click here)
Headlight Dimmer Switch Circuit (Click here)
Harness and connector -
Pre-crash safety city sensor (Click here)
Main body ECU (multiplex network body ECU) (Click here)

*: The condition of the pre-crash safety city sensor can be checked on the Data List.