Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › from 2013.08
RM1440E _57 Power Source / Network _056154 NETWORKING _0274053 CAN COMMUNICATION SYSTEM T

NETWORKING  CAN COMMUNICATION SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Result List of Check CAN Bus Line
Symptom Suspected Area See page
Result of "How to proceed with Troubleshooting" is "Open in CAN Main Wire" Open in CAN Main Wire (Click here)
Result of "How to Proceed with Troubleshooting" is "Short in CAN Bus Lines" Short in CAN Bus Lines (Click here)
Result of "How to Proceed with Troubleshooting" is "Short to B+ in CAN Bus Line" Short to B+ in CAN Bus Line (Click here)
Result of "How to Proceed with Troubleshooting" is "Short to GND in CAN Bus Line" Short to GND in CAN Bus Line (Click here)
Result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line" Open in One Side of CAN Branch Line (Click here)

Communication Stop Mode Table
Symptom Suspected Area See page
"Skid Control (ABS/VSC/TRAC)" is not displayed on intelligent tester Brake Actuator (Skid Control ECU) Communication Stop Mode (Click here)
"Air Conditioning Amplifier" is not displayed on intelligent tester Air Conditioning Amplifier Communication Stop Mode (Click here)
"PPS" is not displayed on intelligent tester Power Steering ECU Communication Stop Mode (Click here)
"Spiral cable (Steering Angle Sensor)" is not displayed on intelligent tester Steering Angle Sensor Communication Stop Mode (Click here)
"Yaw Rate Sensor" is not displayed on intelligent tester Yaw Rate Sensor Communication Stop Mode (Click here)
"ECM (Engine)" is not displayed on intelligent tester ECM Communication Stop Mode (Click here)
"Main Body" is not displayed on intelligent tester Main Body ECU Communication Stop Mode (Click here)
"Combination Meter" is not displayed on intelligent tester Combination Meter ECU Communication Stop Mode (Click here)
"Airbag" is not displayed on intelligent tester Center Airbag Sensor Communication Stop Mode (Click here)
"Four Wheel Drive Control " is not displayed on the intelligent tester*1 4WD Control ECU Communication Stop Mode (Click here)
"Display and Navigation (AVN1)" is not displayed on intelligent tester*2 Audio Receiver Assembly Communication Stop Mode (Click here)

*1: for 4WD

*2: w/ Radio and Display Receiver Assembly