Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Result List of Check CAN Bus Line 
Symptom
Suspected Area
See page
Result of "How to proceed with Troubleshooting" is "Open in CAN Main Wire"
Open in CAN Main Wire
Click here
Result of "How to Proceed with Troubleshooting" is "Short in CAN Bus Lines"
Short in CAN Bus Lines
Click here
Result of "How to Proceed with Troubleshooting" is "Short to B+ in CAN Bus Line"
Short to B+ in CAN Bus Line
Click here
Result of "How to Proceed with Troubleshooting" is "Short to GND in CAN Bus Line"
Short to GND in CAN Bus Line
Click here
Result of "How to Proceed with Troubleshooting" is "Open in One Side of CAN Branch Line"
Open in One Side of CAN Branch Line
Click here

Communication Stop Mode Table 
Symptom
Suspected Area
See page
"Skid Control (ABS/VSC/TRAC)" is not displayed on the Techstream
Brake Actuator (Skid Control ECU) Communication Stop Mode
Click here
"Air Conditioning Amplifier" is not displayed on the Techstream*1
Air Conditioning Amplifier Communication Stop Mode
Click here
"PPS" is not displayed on the Techstream
Power Steering ECU Communication Stop Mode
Click here
"Spiral cable (Steering Angle Sensor)" is not displayed on the Techstream
Steering Angle Sensor Communication Stop Mode
Click here
"Yaw Rate Sensor" is not displayed on the Techstream
Yaw Rate Sensor Communication Stop Mode
Click here
"ECM (Engine)" is not displayed on the Techstream
ECM Communication Stop Mode
Click here
"Main Body" is not displayed on the Techstream
Main Body ECU Communication Stop Mode
Click here
"Power Management1" is not displayed on the Techstream*2
Power Management Control ECU Communication Stop Mode
Click here
"Combination Meter" is not displayed on the Techstream
Combination Meter ECU Communication Stop Mode
Click here
"Certification (Smart)" is not displayed on the Techstream*2
Certification ECU Communication Stop Mode
Click here
"Airbag" is not displayed on the Techstream
Center Airbag Sensor Communication Stop Mode
Click here
"KDSS" is not displayed on the Techstream*3
Suspension Control ECU Communication Stop Mode
Click here
"Four Wheel Drive Control" is not displayed on the Techstream*4
4WD Control ECU Communication Stop Mode
Click here
"Display and Navigation (AVN1)" is not displayed on the Techstream*5
Navigation Receiver Assembly Communication Stop Mode
Click here
"Display and Navigation (AVN1)" is not displayed on the Techstream*6
Audio Receiver Assembly Communication Stop Mode
Click here
  1. *1: w/o Smart Key System
  2. *2: w/ Smart Key System
  3. *3: w/ Kinetic Dynamic Suspension System
  4. *4: for 4WD
  5. *5: for Navigation Receiver Type
  6. *6: for Radio and Display Receiver Type