1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51441
2.REMOVE NO. 1 ENGINE UNDER COVER
3.DRAIN ENGINE OIL
4.DRAIN ENGINE COOLANT
17750A
5.REMOVE AIR CLEANER INLET ASSEMBLY
17700
6.REMOVE AIR CLEANER ASSEMBLY
7.REMOVE EARTH CABLE
Remove the bolt and earth cable.
8.DISCONNECT ENGINE WIRE
Remove the 2 bolts and disconnect the engine wire from the timing chain cover sub-assembly.
27020
9.REMOVE GENERATOR ASSEMBLY
16571C
10.REMOVE NO. 1 RADIATOR HOSE
11101E
11.REMOVE CAM POSITION SENSOR
19500
12.REMOVE IGNITION COIL ASSEMBLY
12262
13.DISCONNECT NO. 2 VENTILATION HOSE
12261
14.DISCONNECT VENTILATION HOSE
77754
15.DISCONNECT NO. 1 CHARCOAL CANISTER OUTLET HOSE (for RHD)
11201
16.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
w/ Air Fuel Ratio Sensor:
Disconnect the air fuel ratio sensor connector and 2 camshaft oil control valve assembly connectors.
w/o Air Fuel Ratio Sensor:
Disconnect the oxygen sensor connector and 2 camshaft oil control valve assembly connectors.
Disconnect the 5 harness clamps and engine wire.
| *1 | Seal Washer and Plate Washer |
Remove the 17 bolts, 2 seal washers, 2 plate washers and cylinder head cover sub-assembly.
11213
17.REMOVE CYLINDER HEAD COVER GASKET
Remove the cylinder head cover gasket.
11159H
18.REMOVE CAMSHAFT BEARING CAP OIL HOLE GASKET
Remove the 2 camshaft bearing cap oil hole gaskets from the camshaft bearing caps.
If any camshaft bearing cap oil hole gasket is missing, check that no camshaft bearing cap oil hole gaskets are stuck to the cylinder head cover sub-assembly.
16603
19.REMOVE NO. 1 IDLER PULLY SUB-ASSEMBLY
16620
20.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
11301K
21.REMOVE CRANK POSITION SENSOR
13471
22.REMOVE CRANKSHAFT PULLEY
16281
23.DISCONNECT NO. 4 WATER BY-PASS HOSE
16572D
24.DISCONNECT NO. 2 RADIATOR HOSE
16031
25.REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT
16326
26.REMOVE NO. 2 WATER INLET HOUSING GASKET
11302
27.REMOVE TIMING CHAIN COVER SUB-ASSEMBLY
| *1 | Gasket |
Remove the 27 bolts and the gasket.
| *a | Protective Tape |
Remove the timing chain cover sub-assembly by prying between the timing chain cover sub-assembly, cylinder head sub-assembly and cylinder block sub-assembly with a screwdriver.
Be careful not to damage the contact surfaces of the timing chain cover sub-assembly, cylinder block sub-assembly, and cylinder head sub-assembly.
Tape the screwdriver tip before use.
Remove the 3 O-rings.
Using an 8 mm socket hexagon wrench, remove the plug.
11302A
28.REMOVE TIMING CHAIN COVER OIL SEAL
| *a | Protective Tape |
| *b | Wooden Block |
Using a screwdriver with its tip wrapped in protective tape and wooden block, remove the timing chain cover oil seal.