Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
*1: for Bulb Type Back-up Light
*2: for LED Type Back-up Light
| Symptom | Suspected Area | Link |
|---|---|---|
| Left or right rear side marker light does not illuminate | Rear combination light assembly |
|
| Symptom | Suspected Area | Link |
|---|---|---|
| License plate light does not illuminate | License plate light assembly |
|
| Harness or connector | - |
*1: for Bulb Type Back-up Light
*2: for LED Type Back-up Light
| Symptom | Suspected Area | Link |
|---|---|---|
| High mounted stop light does not illuminate | Center stop light set |
|
| Harness or connector | - |
*1: for Bulb Type Back-up Light
*2: for LED Type Back-up Light
*1: for Bulb Type Turn Signal Light
*2: for LED Type Turn Signal Light
*3: w/ Memory
*4: for Bulb Type Back-up Light
*5: for LED Type Back-up Light
| Symptom | Suspected Area | Link |
|---|---|---|
| Hazard warning signal lights do not operate | Hazard warning switch circuit |
|
| Combination meter assembly |
|
| Symptom | Suspected Area | Link |
|---|---|---|
| Automatic light control system does not operate | Headlight dimmer switch circuit |
|
| Main body ECU (Multiplex network body ECU) |
|
*1: for Multi-information Display (4.2 Inch Display)
*2: for Multi-information Display (7 Inch Display)