Home › Brake › BRAKE › BRAKE BOOSTER(for 2GR-FE) › from 2016.05
RM24M0E _54 Brake _059558 BRAKE _0291883 BRAKE BOOSTER(for 2GR-FE) A

BRAKE  BRAKE BOOSTER(for 2GR-FE)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read "PRECAUTION" thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION)


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.DRAIN BRAKE FLUID

Hide 85192 4.REMOVE FRONT WIPER ARM HEAD CAP

Hide 5.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

Hide 6.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

Hide 53867H 7.REMOVE FRONT FENDER TO COWL SIDE SEAL LH

Hide 53866J 8.REMOVE FRONT FENDER TO COWL SIDE SEAL RH

Hide 55781F 9.REMOVE COWL TOP VENTILATOR LOUVER

Hide 10.SEPARATE BRAKE MASTER CYLINDER RESERVOIR WITH BRACKET

Hide 11.REMOVE FRONT COWL TOP OUTSIDE PANEL WITH WINDSHIELD WIPER MOTOR LINK

Hide 53292A 14.REMOVE UPPER RADIATOR SUPPORT SEAL (for RHD)

Hide 11209 15.REMOVE V-BANK COVER SUB-ASSEMBLY (for RHD)

Hide 51442 16.REMOVE NO. 2 ENGINE UNDER COVER (for RHD)

Hide 16470 18.SEPARATE RADIATOR RESERVOIR TANK ASSEMBLY (for RHD)

Hide 17190 19.REMOVE INTAKE AIR SURGE TANK ASSEMBLY (for RHD)

Hide 55420A 20.REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY (for LHD)

Hide 55650 21.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)

Hide 55041B 22.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for LHD)

Hide 55447C 23.REMOVE NO. 1 SWITCH HOLE BASE (for LHD)

Hide 55606 24.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

Hide 33504F 25.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for RHD)

Hide 26.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for RHD)

Hide 55041B 27.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for RHD)

Hide 55446A 28.REMOVE NO. 1 SWITCH HOLE BASE (for RHD)

HINT:

Use the same procedure as for LHD. (See page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>REMOVAL)


Hide 67913B 29.REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

HINT:

Use the same procedure as for the LH side. (See page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>REMOVAL)


Hide 62111C 30.REMOVE COWL SIDE TRIM BOARD RH (for RHD)

HINT:

Use the same procedure as for the LH side. (See page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>REMOVAL)


Hide 55606 31.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

HINT:

Use the same procedure as for LHD. (See page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>REMOVAL)


Hide 55432B 32.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Driver Side Knee Airbag)

Hide 55432B 33.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Driver Side Knee Airbag)

Hide 73900 34.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 47201 35.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (for LHD)

Hide 47201 36.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY (for RHD)

Hide 37.DISCONNECT VACUUM HOSE

a.

Move the clip and disconnect the vacuum hose.


Hide 47264A 38.REMOVE PUSH ROD PIN

a.

Remove the clip from the push rod pin.


b.

Remove the push rod pin from the push rod clevis.


Hide 47264D 39.REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Loosen the push rod clevis lock nut.


b.

Remove the push rod clevis.


Hide 40.SEPARATE BRAKE LINE (for LHD)

a.
C307837

Using a union nut wrench, disconnect the 6 brake lines from the brake actuator.


b.
C158100

Using a union nut wrench, disconnect the 4 brake lines.


c.
C158092

Disengage the 5 clamps.


d.
C158095

Remove the bolt and separate the brake lines from the body.


Hide 41.SEPARATE BRAKE LINE (for RHD)

a.
C140017

Disengage the 4 clamps and separate the 2 brake lines.


Hide 42.SEPARATE WIRE HARNESS (for LHD)

a.
C158097

Remove the nut and 2 bolts, and separate the wire harness from the body.


Hide 43.SEPARATE WIRE HARNESS (for RHD)

a.
C140027

Remove the bolt and separate the wire harness.


b.

Disconnect the 3 connectors.


Hide 11101J 44.REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for RHD)

a.
C140018

Remove the bolt and camshaft timing oil control valve assembly.


Hide 44610 45.REMOVE BRAKE BOOSTER ASSEMBLY

a.
C158086

Remove the 4 nuts and brake booster assembly.


Hide 44785 46.REMOVE BRAKE BOOSTER GASKET

Hide 44730 47.REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY

Hide 44696 48.REMOVE CHECK VALVE GROMMET