Home › Steering › POWER STEERING › POWER STEERING ECU(for RHD) › from 2016.05
RM24M0E _55 Steering _059561 POWER STEERING _0291896 POWER STEERING ECU(for RHD) A

POWER STEERING  POWER STEERING ECU(for RHD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 89650 1.INSTALL POWER STEERING ECU

a.
C136581

Install the ECU with the 2 nuts.

NOTICE:

Do not drop or strike the power steering ECU. If dropped or struck, replace it with a new one.


Torque:
13 N*m (138 kgf*cm, 10 ft.*lbf)


b.
C136586

Install the 4 ECU connectors.


c.
C136580

Install the bolt to the ECU bracket.

Torque:
13 N*m (138 kgf*cm, 10 ft.*lbf)


Hide 73900 2.INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55432B 3.INSTALL INSTRUMENT PANEL FINISH PANEL LOWER (w/ Driver Side Knee Airbag)

HINT:

This is symmetrical to the LHD model (See page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>INSTALLATION)


Hide 55432B 4.INSTALL INSTRUMENT PANEL FINISH PANEL LOWER (w/o Driver Side Knee Airbag)

HINT:

This is symmetrical to the LHD model (See page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>INSTALLATION)


Hide 55606 5.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

HINT:

This is symmetrical to the LHD model (See page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>INSTALLATION)


Hide 62111C 6.INSTALL COWL SIDE TRIM BOARD RH

HINT:
·

Perform the same procedure as for the LH side (See page Vehicle Interior>INTERIOR>ROOF HEADLINING>INSTALLATION)

·

This is symmetrical to the LHD model



Hide 67913B 7.INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
·

Perform the same procedure as for the LH side (See page Vehicle Interior>INTERIOR>ROOF HEADLINING>INSTALLATION)

·

This is symmetrical to the LHD model



Hide 55446A 8.INSTALL NO. 1 SWITCH HOLE BASE

HINT:

This is symmetrical to the LHD model (See page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>INSTALLATION)


Hide 55041B 9.INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Hide 10.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 33504F 11.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 12.INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE

Hide 14.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 17.CHECK STEERING WHEEL CENTER POINT

Hide 19. TORQUE SENSOR ZERO POINT CALIBRATION