1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
17705
2.REMOVE AIR CLEANER CAP
Remove the air cleaner cap (see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>THROTTLE BODY>REMOVAL).
17700
3.REMOVE AIR CLEANER CASE
28800
4.REMOVE BATTERY
58534E
5.REMOVE FLOOR CARPET COVER CENTER LH
33820B
6.REMOVE TRANSAXLE CONTROL CABLE ASSEMBLY
Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.
Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.
Disconnect the control cable from the control cable support.
Remove the 2 nuts and disconnect the clamp of the control cable.
Disconnect the control cable from the shift lever.
Using a screwdriver, pull out the stopper of the transmission control cable.
Do not remove the stopper. If the stopper is removed, reinstall it to its original position.
Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.
Do not over rotate the nut as it will come off the interior spring and the transmission control cable will not be reusable.
Remove the 2 bolts and control cable.
33820B
7.INSTALL TRANSAXLE CONTROL CABLE ASSEMBLY
Rotate the transmission control cable nut counterclockwise approximately 180° and, while holding the nut in that position, press in the stopper until it makes 2 "click" sounds.
Install the cable outer of the transmission control cable to the shift lever retainer, check that the position of the spring is the same as A shown in the illustration, and press in the stopper.
If the stopper cannot be pressed in, slightly rotate the nut clockwise and then press in the stopper.
Connect the control cable to the shift lever.
Make sure the cable is installed to the base of the pin.
Install the control cable with the 2 bolts.
Fix the control cable onto the control cable bracket with the clip.
Connect the control cable onto the control shaft lever with the nut.
Connect the clamp of the control cable with the 2 nuts.
Connect the control cable to the cable support.
17700
8.INSTALL AIR CLEANER CASE
17705
9.INSTALL AIR CLEANER CAP
Install the air cleaner cap (see page Engine / Hybrid System>2AZ-FE ENGINE CONTROL>THROTTLE BODY>INSTALLATION).
10.INSTALL BATTERY
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12.INSPECT SHIFT LEVER POSITION
When shifting the lever from P to the R position with the ignition switch on (IG) and the brake pedal depressed, make sure that the shift lever moves smoothly and moves correctly into position.
Start the engine and make sure that the vehicle moves forward when moving the lever from N to the D position and moves rearward when moving the lever to the R position.
If the operation cannot be performed as specified, inspect the park/neutral position switch and check the shift lever installation condition.
13.ADJUST SHIFT LEVER POSITION
58534E
14.INSTALL FLOOR CARPET COVER CENTER LH
15.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.