Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › CLEARANCE SONAR SYSTEM

CLEARANCE SONAR SYSTEM > PROBLEM SYMPTOMS TABLE


HINT:
  1. Before performing verification listed in the table below, check the fuse and relay.
  2. Check the circuits for each problem symptom in the order given in the table below, and proceed to the relevant page.


CLEARANCE SONAR SYSTEM: 
Symptom
Suspected area
See page
Entirely inoperative (Self check does not function).
1. Clearance sonar main switch circuit
Click here
2. Clearance warning indicator
Click here
3. Clearance warning ECU
Click here
Only back sonar does not function (Self check functions normally).
1. Back sonar sensor LH circuit
Click here
2. Back sonar sensor RH circuit
Click here
3. Clearance warning ECU
Click here
Only clearance sonar does not function (Self check functions normally).
1. Front clearance sonar LH circuit
Click here
2. Front clearance sonar RH circuit
Click here
3. Rear clearance sonar LH circuit
Click here
4. Rear clearance sonar RH circuit
Click here
5. Clearance warning ECU
Click here
Although detection can be done, sometimes no buzzer sounds.
1. Clearance warning buzzer circuit
Click here
2. Clearance warning indicator
Click here
3. Clearance warning ECU
Click here
Although detection can be done, sometimes the indicator does not light.
1. Indicator circuit
Click here
2. Clearance warning indicator
Click here
3. Clearance warning ECU
Click here
"Disconnected" or "Frozen" is displayed during the self check.
1. Back sonar sensor LH circuit
Click here
2. Back sonar sensor RH circuit
Click here
3. Front clearance sonar LH circuit
Click here
4. Front clearance sonar RH circuit
Click here
5. Rear clearance sonar LH circuit
Click here
6. Rear clearance sonar RH circuit
Click here
7. Clearance warning ECU
Click here
8. Sensor is wet or frozen
-
The system operates with the shift lever not in R position, or does not operate with the shift lever in R position (Back sonar and rear clearance sonar).
1. Reverse signal circuit
Click here
2. Clearance warning ECU
Click here
Detection can be done although the vehicle speed is 10km/h (6 mph) or more.
1. Speed signal circuit
Click here
2. Clearance warning ECU
Click here
Buzzer volume is too low.
1. Adjust buzzer volume
Click here