2014-2019 Hiace · Service Manual BRAKE

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Jan 2015 – Dec 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017

If there are no DTCs output but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

NOTICE:
When replacing the brake actuator assembly, sensor, etc., turn the ignition switch off.

HINT:
Inspect the fuse and relay before investigating the suspected areas as shown in the table below. Inspect each malfunction circuit in numerical order for the corresponding symptom.

Anti-lock brake system: 
Symptom
Suspected Area
See page
ABS does not operate
Check the DTC again and make sure that the normal system code is output.
Click here
IG power source circuit
Click here
Front speed sensor circuit
Click here
Rear speed sensor circuit
Click here
Check the brake actuator with the intelligent tester. If abnormal, check the hydraulic circuit for leakage.
-
Front skid control rotor
Click here
Rear skid control rotor
Click here
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the brake actuator assembly.
Click here
ABS does not operate efficiently
Check the DTC again and make sure that the normal system code is output.
Click here
Front speed sensor circuit
Click here
Rear speed sensor circuit
Click here
Stop light switch circuit
Click here
Check the brake actuator with intelligent tester. If abnormal, check that hydraulic circuit for leakage.
-
Front skid control rotor
Click here
Rear skid control rotor
Click here
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to normal, replace the brake actuator assembly.
Click here
ABS warning light abnormal (Remains on)
ABS warning light circuit
Click here
Brake actuator assembly
Click here
ABS warning light abnormal (Does not come on)
ABS warning light circuit
Click here
Brake actuator assembly
Click here
ABS sensor DTC check cannot be done
Check the DTC again and make sure that the normal system code is output.
Click here
TC and CG terminal circuit
Click here
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to normal, replace the brake actuator assembly.
Click here
Test mode (Signal check) cannot be done
TS and CG terminal circuit
Click here
Brake actuator assembly
Click here
← PROBLEM SYMPTOMS TABLE (Oct 2014 – Dec 2014)PROBLEM SYMPTOMS TABLE (from Jan 2017) →