| Stop and start system does not operate
|
Stop and start system operation prohibition based on the battery conditions (Refer to "Stop and Start System does not Operate (Battery Condition)")
|
|
| Engine hood courtesy switch circuit
|
|
| Driver door courtesy switch circuit (system prohibits control)
|
|
| Driver door courtesy switch circuit
|
|
| Driver seat belt buckle switch circuit (system prohibits control)
|
|
| Front seat inner belt assembly (for driver side)
|
|
| Air conditioning system (system prohibits control)
|
|
| Air conditioning system (for Automatic Air Conditioning System)
|
|
| Air conditioning system (for Manual Air Conditioning System)
|
|
| Brake booster vacuum is low (system prohibits control)
|
|
| Brake booster vacuum is low
|
|
| Backup boost converter circuit
|
|
| Neutral position switch circuit
|
|
| Starter signal circuit
|
|
| STA signal circuit
|
|
| Starter inrush current reduction relay circuit
|
|
| Crank position sensor
|
|
| ECM
|
|
| Relay
|
-
|
| Vacuum sensor assembly
|
|
| Brake booster assembly
|
|
| Electromagnetic oil pump (for Automatic Transmission)
|
|
| Starter assembly
|
|
| The deceleration sensor zero point calibration is performed
|
|
| Stop and start system does not operate
|
Deceleration sensor (airbag sensor assembly)
|
|
| Skid control ECU (brake actuator assembly)
|
|
| CAN communication system (for LHD (w/ Centrl Gateway ECU))
|
|
| CAN communication system (for RHD (w/ Centrl Gateway ECU))
|
|
| CAN communication system (for LHD (w/o Centrl Gateway ECU))
|
|
| CAN communication system (for RHD (w/o Centrl Gateway ECU))
|
|
| Engine stop and start ECU
|
|
| Battery*1
|
|
| Wire harness or connector
|
-
|
| Starter assembly does not operate
|
Battery
|
|
| Starter assembly
|
|
| Park/neutral position switch assembly (for Automatic Transmission)
|
|
| Neutral position sensor (neutral position switch) (for Manual transmission)
|
|
| Entry and start system (for start function) (w/ Entry and Start System)
|
|
| ECD system
|
|
| Starter signal circuit
|
|
| Cranking speed decreases
|
Battery
|
|
| Starter inrush current reduction relay circuit
|
|
| Starter assembly
|
|
| Stop and start cancel indicator light does not operate
|
Combination meter assembly
|
|
| Indicator circuit (CAN communication system)
|
|
| Engine stop and start ECU
|
|
| Stop and start indicator light does not operate
|
Combination meter assembly
|
|
| Indicator circuit (CAN communication system)
|
|
| Engine stop and start ECU
|
|
| Stop and start control cannot be canceled
|
ECAN terminal voltage
|
|
| Stop and start cancel switch circuit
|
|
| Engine not stopped by stop and start control (stop and start operation prohibited)
|
Engine hood courtesy switch circuit
|
|
| Driver side door courtesy switch circuit
|
|
| Stop light switch assembly
|
|
| Clutch start switch assembly (for lower) (for Manual Transmission)
|
|
| Clutch switch assembly (for upper) (for Manual Transmission)
|
|
| Engine stop and start ECU
|
|
| The shift lever is operated without depressing the clutch pedal (system operation prohibition) (for Manual Transmission)
|
|
| Multi-information display screen does not change after pressing steering pad switch assembly.
|
Stop and start priority control system
|
|
| Multi-information display screen changes without pressing steering pad switch assembly
|
Stop and start priority control system
|
|
| Multi-information display screen does not change but control mode changes
|
Stop and start priority control system
|
|
| Multi-information display screen changes but control mode does not change
|
Stop and start priority control system
|
|
| Control mode returns to default mode after turning ignition switch ON
|
Stop and start priority control system
|
|